Loading ...
Loading ...
Loading ...
Disposal en
13
WARNING‒Risk of fire!
The hob switches off automatically and can no longer
be operated. It may switch on unintentionally at a later
point.
▶ Switch off the fuse in the fuse box.
▶ Call the customer service.
14.1 Information on display panel
Fault Cause and troubleshooting
None There has been a power cut.
1.
Check the household fuse for the appliance.
2.
Check whether there has been a power failure by trying other electrical appliances.
All displays flash The control panel is wet or objects are lying on it.
▶
Dry the control panel or remove the object.
Several hotplates have been used over a prolonged period at high power settings. The hot-
plate has been switched off to protect the electronics.
1.
Wait a while.
2.
Touch any touch field.
a When the message no longer appears, the electronics have cooled down sufficiently.
You can continue to cook.
Despite being switched off by , the electronics have become hot again. All hotplates
have therefore been switched off.
1.
Wait a while.
2.
Touch any touch field.
a When the message no longer appears, the electronics have cooled down sufficiently.
You can continue to cook.
and the heat set-
ting flash alternately.
A signal sounds.
Hot pot near the control panel. There is a risk that the electronics will overheat.
▶
Remove the pan.
a The display goes out shortly afterwards.
and audible signal
Hot pot near the control panel. The hotplate has been switched off to protect the electron-
ics.
1.
Remove the pot.
2.
Wait a while.
3.
Touch any touch field.
a When the message no longer appears, the electronics have cooled down sufficiently.
You can continue to cook.
The hotplate was on for too long and has switched off automatically.
You can switch the hotplate back on again immediately.
and hotplates do
not heat up
Demo mode is activated.
1.
Disconnect the appliance from the power supply for 30seconds by briefly switching off
the circuit breaker in the fuse box.
2.
Touch any touch field within the next threeminutes.
A message with "E"
appears on the dis-
play, e.g. E0111.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page14
15 Disposal
15.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
▶
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Loading ...
Loading ...
Loading ...