Loading ...
Loading ...
Loading ...
HDL 26-A INPUT PANEL
1
FEMALE XLR INPUTS (BAL/UNBAL). The system accepts XLR input connectors.
2
MALE XLR SIGNAL OUTPUT. The output XLR connector provides a loop through for speakers daisy chaining. The balanced
connector is connected in parallel and can be used to send the audio signal to other amplified speakers, recorders or supplementary
amplifiers.
3
SYSTEM VOLUME KNOB
4
SIGNAL / LIMITER LED. The LED light is green when a signal is applied to the speaker. It turns RED when the speaker
compressor activates.
5
POWER LED. This green led is ON when the speaker is connected to the main power supply.
6
LINK LED. This LED turns on when the speaker is connected to RDNet.
7
ACTIVE LED. This LED blinks when the speaker is transmitting data over RDNet.
8
RDNET DATA INPUT AND DATA LINK. The RDNET IN/OUT PLUG SECTION features etherCON connectors for the RCF RDNet
protocol. This allows the user to completely control the speaker using the RDNet software.
9
NEAR / FAR. Use the Near / Far button if you want to apply a Near or a Far Equalization.
10
BYPASS / LOCAL SETUP. When pressed, the setup is loaded from the internal memory that only RDNet can write. Every time
the speaker is turned on, the last stored configuration is applied.
When the button is released, the speaker uses its local setup and will not remember its last RDNet setup when turned on again.
1
2
8
9
10
7
3
64
5
Loading ...
Loading ...
Loading ...