Loading ...
Loading ...
Loading ...
35
EN
Delay start selection
This button allows you to programme the
start of the wash cycle, with a delay
between 0:30 and 24 hours.
To set the delayed start proceed as follows:
1. Switch on the dishwasher by holding
down the "ON/OFF"
button for about
3 sec.
2. Select the washing programme.
3. Press the "DELAY START"
button
("0:30" will appear on the display).
4. Press the button again to increase the
delay (each time it is pressed, the delay
is increased by 30 minutes, up to a
delay of 4 hours, after each time the
button is pressed it will increase by 1
hour up to a maximum of 24:00.
Pressing the button again after a delay
of 24:00 will return to 0:00 (delayed
start disabled).
5. The delayed start settings will remain
visible on the display for 5 seconds, or
until the ON/OFF - PROGRAM
SELECTION - START/RESET buttons
are pressed.
Countdown and Programme start with
DELAY START
When the delay is set on a programme:
after pressing "START/RESET"
.
The "DELAY START" light stays on until
the end of the time.
The delayed time countdown starts
showing on the display "START IN XX:
XX".
The time will be displayed with 30-minute
intervals over 24 hours and one-minute
intervals over the last 2 hours.
Pressing any button (except the "ON/
OFF, Wi-Fi Enrollment, START/RESET"
buttons for 3 seconds, the programme
name "P XX NAME" is displayed (P +
programme number + programme name)
for one single scroll and then the delay
time is displayed again.
If you want to cancel the delayed start
proceed as follows:
Press and hold the "START/RESET"
button for at least 3 seconds. The display
will show "RESET" and beeps will sound.
The delayed start and the selected
programme will be cancelled. Two
dashes will appear on the display.
At this point, if you want to start the
dishwasher, you will need to set the
desired programme again and select the
option buttons if necessary.
DEMO MODE ACTIVATION
ALWAYS start the procedure with the
dishwasher turned off.
Activation or exclusion of the DEMO
MODE program:
(demonstration program to be used
exclusively in points of sale)
In the event of a power failure or
shutdown, the dishwasher stores the
time remaining at the start, which will
be resumed at the poi
nt where it was
interrupted once the power supply is
restored or the machine is switched
on again.
When you press the DELAY START
button, the last setting made will be
displayed.
Changing the programme does not
change the delay time and the LED will
remain on.
DELAY START button
Loading ...
Loading ...
Loading ...