Loading ...
Loading ...
Loading ...
4
USING THE HEATER
TEMPERATURE SETTING
1. You may adjust the desired temperature setting in any heater operation
mode.The temperature can be set from 50°F to 95°F.
2. Press the or button to adjust the temperature setting.
- The heater will operate in LOW HEAT mode and blow warm air when the set
temperature is 2°F-4°F higher than the room temperature.
- The heater will operate in HIGH HEAT mode and blow hot air when the set
temperature is more than 4°F higher than the room temperature.
- When the room temperature reaches the set temperature the heater will
automatically go into FAN MODE and blow unheated air.
NOTE:The heater will cycle between FAN MODE and LOW HEAT MODE as it
maintains the set temperature.
SAFETY FEATURES
A thermal overload protector is built into the heater to automatically shut the heater
off if it becomes overheated. The heater must cool down and be reset before it will
operate again.To reset,turn the Main Power Switch button to Off and then back
ON.Press the button on the control panel to resume normal operation.Be sure
that the heater is on a smooth level surface with no obstructions.The heater is also
equipped with a safety tip-over switch to turn power off to the heater when the heater
tip over.To resume heater functions simply stand heater upright.With tip over
protection, the heater will only operate when placed upright on a level surface.
REMOTE CONTROL
The remote control uses on button cell battery,type CR2025(3V).To remove the
battery carriage use your thumb to squeeze the release tab to the right and then pull
the carriage out.Place the battery into the carriage and slide the carriage back into
the remote.See Fig.4. We recommend the use of a Lithium-ion battery for longer
use.NOTE:Follow battery disposal instruction on battery packaging, or contact your
local safety council for safely disposal of batteries.
Before using the remote control,you must remove the insulating film as shown in the
figure below.
1. All functions performed with remote control work identically to the heater control
panel.
2. Aim the remote control at the heater control panel to operate the heater.
SPECIFICATIONS
Model No 820-249V80
Voltage 120V AC
Frequency 60Hz
Output Power (W) 1500W
Fig. 4