Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Powercord not plugged in. Plug into a grounded 3 prong outlet.
Stops No power at plug. Check electrical source or call
electrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. If problem continues, call electrician.
Using an extension cord. Do not use extension cords.
Timer is not lined up. Turntimer to the right slightly
and pullto start.
Timer knob not pulled out. Set and pull out knob.
Washer at pause in Allow cycle to continue
PERMANENT PRESS II Cycle (see "OperatingYourWashe¢').
(approximatelytwo minutes).
Machine is overloaded. Wash smaller loads.
Agitator Not The top of the agitator moves This is normal.
Working only in onedirection.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator is much This is normal.
Too Low/Not higherthan the highest water
Completely Ievel.This creates a perception
Filling of the washer not being fuIl.
Tub is Tubpulled forwardwhen Ensure tub is centered before
Crooked unloading, starting washer.
Tubmoves. This is normal.
Unit not level. Ensure front feet are installedand
nuts are tightened. Levelwasher.
Reset rear legs (see "lnstalIation
Instructions").
Lint on Load Improper sorting. Sort lint givers from lint takers
and bycolor.
Overloading. Lint can be trapped in load if
overloaded.Wash smaller loads.
Paperor tissue in pockets. Clean out pockets beforewashing.
Not enough detergent. Use enough detergent to
hold lint in water.
Detergent not dissolving. Use AutomaticTemperatureControI
Watertemperatures lower (ATC).ATC ensures wash water
than 70°F (21°C). temperature will be warmer than
70°F (21°C).
32
Loading ...
Loading ...
Loading ...