Loading ...
Loading ...
Loading ...
Most laundering problems are easily solved if you understand the cause.
Check these lists for common laundry and washer problems, if you need
further assistance, see service and assistance information on the back page,
Problem Possible Cause Solution
Washer Leaks Household plumbing is leaking. Repairplumbing.
Inlet hoses not tight. Tighten hoses (see "Installation
Instructions").
Inlet hose washers not Reseatwashers (see "Installation
properly seated. Instructions")
Drain hose not properly Clamp drain hose (see 'Installation
clamped or is off. Instructions")
Drain is clogged. Removedrain clogs. Sink, standpipe,
or floor drain must be able to handle
17 gaI (64 L) of water per minute.
Tub moved forwardduring Ensuretub is centered before
unloading, causingwater to starting washer.
deflect off tub ring.
Unit not levelcausing water Ensure front feet are installedand
to deflectoff tub ring. nuts are tightened. LeveIwasher.
Reset rear legs(see "Installation
Instructions").
Load isunbalanced.Spray Redistributethe load.
rinsesare deflecting off load.
Washer is overloaded. Fills or Reduceload size.
spray rinses are deflecting off
load.
Won't Drain/ Drain hose is kinked or Straightenor unplug hose
Won't Spin/ clogged. (see"Installation Instructions")
Wet Loads Correct operation of After awash or rinse, the washer will
neutraldrain, drain without spinning. After draining,
the spinning begins.
Lid isopen. Closethe lid,
Drain hose is more than Lowerdrain hose (see "Installation
96 in.(2.4 m) above floor. Requirements"),
Too much detergent- Use less detergent.
excessivesudsing.
Wrong cycle for load Choosea cycle with a higher spin
beingwashed, speed (see"Operating Your
Washer").
3O
Loading ...
Loading ...
Loading ...