Makita HU06Z User Manual

Loading ...

7 ENGLISH

Overdischarge protection

When the battery capacity is not enough, the tool stops automati-

cally. If you turn the tool on, the motor runs again but stops soon. In

this case, remove the battery from the tool and charge the battery.

Switch action

WARNING: Before installing the battery car-

tridge into the tool, always check to see that the

switch trigger actuates properly and returns to

the "OFF" position when released.

WARNING:

For your safety, this tool is equipped

with the lock-off button which prevents the tool from

unintended starting. Never use the tool if it starts when

you pull the switch trigger without pressing the lock-off

button.AskyourlocalMakitaServiceCenterforrepairs.

WARNING: Never disable the lock function or

tape down the lock-off button.

NOTICE:

Do not pull the switch trigger forcibly with-

out pressing the lock-off button.Theswitchmaybreak.

►1. Switch trigger 2. Lock-off button

Tostartthetool,pressthelock-offbuttonandpullthe

switchtrigger.Releasetheswitchtriggertostop.Thelock-

off button can be pressed from either the right or left side.

Indicator lamp

Theindicatorlampblinksorlightsupwhentheremain-

ingbatterycapacityisloworempty.Theindicatorlamp

also lights up when the tool becomes overloaded.

►1. Indicator lamp

Lamp status and action to be taken

Indicator lamp Status Actiontobetaken

Thelampblinks

red.

Theremaining

battery capacity

is low.

Charge the battery.

Thelamplightsup

red. *

Thetoolhas

stopped because

the remaining

battery capacity is

empty.

Charge the battery.

Thetoolhas

stopped due to

overload.

Turnoffthetool.

*Thetimeatwhichtheindicatorlamplightsupvariesdepending

on the temperature around the work area and the battery car-

tridge conditions.

Adjusting the shearing height (for

grass shear)

CAUTION: When changing the shearing

height, be sure to attach the blade cover and be

careful not to trap ngers between the tool and

grass receiver.

Theshearingheightcanbesettothreelevels(15mm

(9/16"), 20 mm (13/16"), and 25 mm (1")) by changing

thexedpositionofthegrassreceiver.Theshearing

height without the grass receiver is about 10 mm (3/8").

Slide the grass receiver toward the front of the tool.

►1. Grass receiver

2. Changethexedpositionofthegrassreceiverby

moving it in the direction of the arrow.

Loading ...

Makita HU06Z 12V max CXT Lithium‑Ion Cordless Hedge Trimmer, Tool Only

User Manual - Page 7