Loading ...
Loading ...
Loading ...
-7-
INSTALLATION
NOTE: ALL ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY A QUALIFIED
PERSON.
Each fryer should be connected to an adequately protected power supply and an isolation switch mounted
adjacent to, but not behind fryer. This switch must be clearly marked and readily accessible in case of fire.
1. Check electricity supply is correct as shown on Rating Plate attached to the RH foot of the fryer.
2. Supply terminal connections are located at lower front of fryer.
3. Remove the service panel (screws on underside of chassis) to allow connection access for the
electrical supply.
4. Bring the supply cable up through the compression type gland provided on rear of main electrical
switchgear panel.
5. Connect mains supply to L1, L2 and L3 fuse carrier connections for 3 phases.
6. Connect neutral and earth conductors to neutral stud and earth stud respectively.
7. For all connections, ensure that conductors are secure and appropriately terminated.
8. Tighten cable gland to secure against tension on cable.
NOTE:
This appliance must be grounded / earthed.
Fixed wiring installations must incorporate an all-pole disconnection switch.
Each fryer should be connected to an adequately protected power supply and isolation switch mounted
adjacent to, but not behind the fryer. This switch must be clearly marked and readily accessible in case of
fire.
The fryer is equipped with 32A fusing on L1, L2 and L3 supplies. Ensure fuses are fitted (Type F1(NS) gG).
Loading ...
Loading ...
Loading ...