Loading ...
Loading ...
Loading ...
Connecttheotherend of the BLACK
cable to good CHASSIS GROUND,
away_from fuel tank and battery..
"O REMOVE CABLES, REVERSE
:)RDER -
Remove BLACK cable first from chassis
and then from the fully charged battery.
Remove RED cable last from both bat-
-teries.
PositiveTerminal
Negative Terminal
Headlight
Wire
Connector
ed
Battery
PositiveTerminat- Negative Terminal
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the
backside of the grill.
• Replace bulb inholder and push bulb
holder securely back into the hole in the
backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
t- Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual, "-
_TO REPLACE FUSE
Replace with 30 amp..,automotive-type
plug-in fuse. The fuse-holder is located
behind the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
• Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at
sid_sr-tJb-towa_d engine and lift off of
tractor;
• To ]_ac_.reverse above procedures.
ENGINE
Maintenance, repair, or replacement ofthe
emission controldevices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishmentor indi-
vidual. Warranty repairs must be per-
form.ed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttlecontrol has been presetat the
factory and adjustmentshould not be nec-
essary. Check adjustment as described
below before looseningcable. If adjust-
ment is necessary, proceed as follows:
• W'_hengine not running,move throttle
controllever from slow to choke posi-
tion.Slowly move lever from choketo
fast position.
• Check to see if hole inthrottlelever and
hole in speed controlbracket are
aligned.
• If holes are not aligned, loosen cable
clamp screw an..d.alignthe holesby
insertinga pencil or a 1/4" drillbit
throughboth holes.
• Pullthrottle cable upto remove slack
and.tighten cable clamp screw. Remove
alignmentpencil or drillbit.
Cable
Screw
Speed Control
Bracket
27
Throttfe-Eever
Loading ...
Loading ...
Loading ...