Loading ...
Loading ...
Loading ...
8
ASSEMBLY & USE
WICK FILTER ASSEMBLY
1. DO NOT pre-soak the anti-microbial wick filters.
2. Open the filter cover by gently pulling the end with the finger notch until it swings
open like a door. There are 2 notches on the insides to help keep the door closed.
Try pulling up and out to open.
3. Place wick filter along the inside before closing the cover until it snaps closed.
4. Insert filter covers into the sides of the base (see LIST OF MAIN PARTS: Fig. 1)
5. Remove and turn the wick filter over every time the water tank is refilled to extend
the life of the wick.
TANK ASSEMBLY
1. Lift the Water Tank straight up from the base, turn it upside down, unscrew the Water
Cap and fill with cool water only.
DO NOT fill water all the way to the rim
DO NOT add any medication, essential oils, or salt to the water.
2. Screw Water Cap back on. Make sure the silicone ring is in place to avoid leaking. Turn
the Water Tank over and place securely on the base. DO NOT move the humidifer once
the tank is placed on the base. This could cause leakage and spills.
3. Plug the power cord into a wall socket and press the power button. The power light will
illuminate one green water droplet for low. Press again to change to medium; the light
will illuminate 2 green water droplets. Press a third time to change to high; the light will
illuminate 3 green water droplets. Press a fourth time to power off the humidifier.
Note: You will not see visible mist rising from the unit during operation.
4. When the humidifier runs out of water, the center power light will illuminate red and the
fan will stop as a safety feature. Turn the humidifier off and unplug before removing and
refilling the Water Tank.
Loading ...
Loading ...
Loading ...