Loading ...
Loading ...
Loading ...
13
To disconnect a nozzle from the spray wand
Turn off the pressure washer and shut off the water supply. Pull the trigger to release water pressure.
Engage the safety lock on the trigger handle .
Remove the nozzle by placing your hand over the nozzle while pulling back on the Quick-Connect
collar.
WARNING:Do not make changes to the nozzle while the trigger is engaged. Doing so could
result in damage to the pressure washer or injury to the user.
WORKING WITH DETERGENT
WARNING: Use only detergents specifically designed for use with pressure washers.
DO NOT USE household detergents, acids, alkaline solutions, bleaches, solvents, flammable material,
or industrial grade solutions. These could damage the pressure washer. Many detergents may require
mixing prior to use. Prepare the cleaning solution as instructed on the solution bottle.
WARNING: When being used with detergent, make sure to use the black soap
quick-nozzle.
Gently pull the detergent tank out of its storage position. Remove the
detergent tank cap with suction tube (Fig.12).
Fill the tank or mix as recommended by detergent instructions, and
secure the cap with suction tube back into place. Replace it back on
the unit.
Install the soap nozzle (black) on the spray wand.
Turn on the pressure washer. Pull the trigger to operate the unit.
When finished using the pressure washer, you must first drain and
rinse the detergent tank. Run the pressure washer until all of the soap
is drained from the detergent tank.
FINISH OPERATION
1. Turn off the water source.
2. Press the lever on the trigger gun to release any remaining pressure and water in the system.
3. Turn the switch to the OFF position and unplug the power cord from the outlet.
4. Disconnect the high-pressure hose connection on the trigger gun handle.
5. Store the water hose and high pressure hose.
Loading ...
Loading ...
Loading ...