Loading ...
Loading ...
Loading ...
XGPS150
7
Pairing with your device
Pairing is the process connecting two devices over
Bluetooth and allowing them to communicate. You
will need to go through the pairing process each
time you use the XGPS150 with a new device, and
the XGPS150 will automatically try to reconnect to
the last device it was paired with.
NOTE: If your device requires a code to connect
during the pairing process, use “0000” or “1234”.
Pairing the XGPS150 with the iPod touch, iPad
or iPhone
(NOTE: these instructions were written using iOS
version 4.1 and may be different if you are using a
different version of the iPhone OS.)
• Make sure the mode switch on the XGPS150
is set correctly for your device (see Setup).
• On the touch/iPad/iPhone device, go to:
Settings->General->Bluetooth
and turn on Bluetooth. The device will automati-
cally begin looking for the XGPS150.
• Turn on the XGPS150. The blue Bluetooth
status light on the XGPS150 will begin to blink
slowly (about once per second).
• After a few seconds, the XGPS150 will appear
as
XGPS150-xxxxxx in the list of devices on
the touch/iPad/iPhone screen. (The last 6 digits
Loading ...
Loading ...
Loading ...