Loading ...
Loading ...
Loading ...
28. FX SEND Fader: Control aect Input signal level.
29. MP3 VOL Fader: Change VOL button can be control the VOL of Mp3.
30. MAIN MIX Fader: You use the high precision quality faders to control the output level of
the main mix.
31. POWER Switch: Use the POWER switch to turn on the mixing console. The POWER switch
should always be in the "O'' position when you are about to connect your unit to the
mains. To disconnect the unit from the mains, pull out the main cord plug. When installing
the product, ensure that the plug is easily accessible.
32. FUSE HOLDER/IEC MAINS RECEPTACLE: The console is connected to the mains via the
cable supplied, which meets the required safety standards. Blown fuses must only be
replaced by fuses of the same type and rating. The mains connection is made via a cable
with IEC mains connector. An appropriate mains cable is supplied with the equipment.
33. AMPLIFIER OUTPUT: Connect with two 4ohm speakers.
34: COOLING FAN: Cooling the amplier to avoid the amplier too hot to be broken.
www.PyleUSA.com
11
www.PyleUSA.com
12
4/6/8/12/16 Input Channel Mixer, New Multi-
Voltage Power Supply for Worldwide Use
• Built-in Wireless BT connects the mobile phone
or in other BT player
• Built-in MP3 player that supports variety of
music formats
• Connect the computer to record and play music
• Digital DSP, 16 Multi-FX effects
• Ultra -musical 3-band EQ on all channels
• Peak LED all Channels
• High accurate level indicator
• Phantom power switch (+48V )
• Sealed rotary controls to resist dust and grime
• Rugged steel chassis
1. GAIN Control: Adjusts the input signal level. To get the best balance
between the S/N ratio and the dynamic range, adjust the gain so that the
PEAK indicator Slights only occasionally and briey on the highest input
transients. The -60 to +10 scale is the MIC input adjustment range. The 40
to +10 scale is the LINE input adjustment range.
2. Equalizer 3 (HIGH, MID and LOW): This three-band equalizer adjusts
the channel's high, mid and low frequency bands. Selling the knob to the
"0" position produces a at response in the corresponding band. Turning
the knob to the right boosts the corresponding frequency band, while
turning to the left attenuates the band.
3. AUX1/AUX2 Control:
[AUXI] Control: This control adjusts the level of the inputsentto the AUX1
output (refer to numeral 36 in section MAIN TERMINALS on page 10).
[AUX2] Control: This control adjusts the level of the input sent to the
AUX2 output (refer to numeral 35 in section MAIN TERMINALS on page 10).
4. FX Control: Adjusts the level of the signal sent from the channel to the
FX SEND buses.
Loading ...
Loading ...
Loading ...