Loading ...
Loading ...
Loading ...
WerecommendCraftsmanbrand
syntheticoil.Mixgasolineandoilat a
ratio of 40:1. A 40:1 ratio is obtained
by mixing 3.2 ounces of oil with 1
gallon of unleaded gasoline. Included
with this trimmer is a 3.2 ounce
container of oil. Pour the entire
contents of this container into 1 gallon
of gasoline to achieve the proper fuel
mixture. DO NOT USE automotive oil or
boat oil. These oils will cause engine
damage. When mixing fuel, follow
instructions printed on container.
Once oil is added to gasoline, shake
container momentarily to assure that
the fuel is thoroughly mixed. Always
read and follow the safety rules
relating to fuel before fueling your unit.
IMPORTANT
Experience indicates that alcohol
blended fuels (called gasohol or using
ethanol or methanol) can attract mois-
ture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage. To avoid en-
gine problems, empty the fuel system
before storage for 30 days or longer.
Drain the gas tank, start the engine and
let it run until the fuel lines and carbure-
tor are empty. Use fresh fuel next sea-
son. Never use engine or carburetor
cleaner products in the fuel tank or per-
manent damage may occur.
See the STORAGEsection for additional
information.
HOW TO STOP YOUR UNIT
• To stop the engine, move the ON/
OFF switch to the OFF position.
HOW TO START YOUR UNIT
_ WARNING: The trimmer head
will turn while starting the engine.
Avoid any contact with the muffler. A
hot muffler can cause serious burns.
STARTING A COLD ENGINE
NOTE: DO NOT squeeze the throttle
trigger until the engine has started and
runs.
1. Set unit on a flat surface.
2. Move ON/OFF switch to the ON
position.
3. Slowly press the primer bulb 6
times.
4. Move the start lever to the START
position.
Start Lever
Handle
Primer Bulb Muffler
5. Pull starter rope handle sharply
until engine starts and runs.
6. Allowunit to runfor 10-15 seconds,
then fully squeeze the throttle trigger
to disengage the starting system.
STARTING A WARM ENGINE
1. Move ON/OFF switch to the ON
position.
2. Move the start lever to the RUN
position.
3. Squeeze and hold the throttle trig-
ger. Keep throttle trigger fully
squeezed until engine runs
smoothly.
4. Pull starter rope sharply while
squeezing throttle trigger until en-
g=ne runs.
NOTE: Normally, the warm starting
procedure can be used within 5-10
minutes after the unit is turned OFF. If
the unit sits for more than 10 minutes
without being ran, it will be necessary
to start the unit by following the steps
under STARTING A COLD ENGINE or
following the starting instruction steps
shown on the unit.
STARTING A FLOODED ENGINE
Flooded engines can be started by
placing the ON/OFF switch in the ON
position. Move the start lever to the
RUNposition and fully squeeze throttle
trigger. Pull the starter handle repeat-
edly while squeezing throttle trigger
until engine starts and runs. This
6
Loading ...
Loading ...
Loading ...