Loading ...
Loading ...
Loading ...
REPLACE SPARK PLUG
Replace the spark plug each year to
ensure the engine starts easier and
runs better. Set spark plug gap at
0.025 inch. Ignition timing is fixed and
nonadjustable.
LINE REPLACEMENT
Pre-wound spools offer the most con-
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and discard.
3. Replace with Champion RCJ-6Y
spark plug and tighten securely with
a 3/4 inch socket wrench.
4. Reinstall the spark plug boot.
venient method for replacing line and
ensuring optimum performance.
* Replacement spools are celor-ceded
to ensure use of the correct spool with
your unit. Be sure to use the same
color spool as the existing spool.
NOTE: Always clear dirt and debris
from cutting head components when
performing any type of maintenance.
, Hold spool and unscrew cap by turning
in the direction shown on top of the cap.
* Remove line guide ring and spool.
Use a pre-wound spool or refill spool
with line. If using a pre-wound spool,
remove tape strip from line and spool.
REFILLING THE SPOOL WITH LINE
_ WARNING: Use only 0.080
inch (2 mm) diameter round line.
Other sizes and shapes of line will not
advance properly and will result in im-
proper cutting head function or can
cause serious injury. Do not use other
materials such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious injury.
1. Cut a length of 25 feet of 0.080 inch
b ram) diameter round Craftsman
rand line.
Feed line in /f//_\"_
direction
shown on
spool.
Spool
2, Insert one end of line into center
cavity of empty spool. Ensure line
will feed into spool in the direction
shown on the spool (counterclock-
wise).
3. Continue feeding line into spool,
leaving 4 - 6 inches (10 - 15 cm)
unwound from center of spool.
INSTALLING SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Line through guide ring #
tt
X Sloti,_.__
Replacement Spool
3. Rest guide ring on spool and place
line through slot. Allow line to ex-
tend 4 - 6 inches (10 - 15 cm) from
center of spool.
4. Ensure line remains in slot while
screwing cap on to the shaft. Only
tighten cap hand tight!
lO
Loading ...
Loading ...
Loading ...