Loading ...
Loading ...
Loading ...
5INSTALLATION
WARNING
WARNING
To avoid any potential hazard, you must follow our
instructions when you install your appliance. Failure
to install the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
• This appliance must be installed by an authorised
person according to all codes and regulations as
stated in the local municipal building code and other
relevant statutory regulations.
• Refer to data plate for rating information. The data
plate is positioned behind the bottom of the oven door.
WARNING
WARNING
This appliance must be properly earthed.
• This range must be connected with cable of 90°C
rating minimum.
• This product has passed the insulation resistance test
after manufacture. If the resistance reading is low at
installation, it is probably caused by moisture from
the atmosphere being absorbed by the elements
after the range has been produced. (Pass at 0.01MΩ
AS/NZS 3000 Wiring Rules).
• Do not lift the appliance by the door handles.
• Prepare the cupboard opening to match your
appliance measurements. (See diagrams)
• Slide appliance into the cupboard, ensuring that the
supply cable (where fitted) does not kink.
• To prevent tipping, use the screws supplied to secure
your oven into the cupboard. Use just 2 screws for
underbench and separate grill underbench ovens,
and 4 screws for separate grill wall ovens. Remove
the bottom door in separate grill wall ovens to
provide access to the bottom 2 screwing points.
• For appliances fitted with a flexible supply cord,
if the cord is damaged, it must be replaced by
the manufacturer or its service agent or similarly
qualified person in order to avoid a hazard. The plug
must be accessible after installation.
• Where the appliance is built into a cabinet, the cabinet
material must be capable of withstanding 70°C.
Installation into low temperature tolerant cabinetry
(e.g. vinyl coated) may result in deterioration of the
low temperature coating by discolouring or bubbling.
• If the appliance is installed adjacent to vinyl-wrapped
surfaces, use an installation kit available from the
vinyl-wrap supplier.
• Electrolux Home Products cannot accept
responsibility for damage caused by installation into
low temperature tolerant cabinets.
• After installation, test and ensure that the
appliance operates correctly before handing it
over to the customer.
• If a powerpoint is fitted it must be accessible with the
appliance installed, as the plug must be accessible
after installation.
• This appliance must be mounted on a flat surface
for the full width and depth of the product.
• To avoid overheating, the appliance must not
be installed in a recess or cupboard behind a
decorative door.
It is recommended that this product is not installed
in an unvented living space, particularly if that space
incorporates sleeping quarters.
WARNING
CAUTION
To avoid any potential hazard, you must follow our
instructions below when you install your appliance.
Failure to install the appliance correctly could invalidate
any warranty or liability claims and lead to prosecution.
This appliance is only suitable for connection to fixed
consumer piping where the maximum over-pressure is
limited to 14kPa or less. Refer to AS/NZS 5601.
Cabinet construction for your appliance
For the best integration within a kitchen, install this
appliance in a standard 600mm wide cupboard that gives
a flush fit with the surrounding cupboard fronts (Figure A).
A recess of 20mm is ideal. It can also be installed using
a proud fit with the surrounding cupboard (Figure B).
NOTE: Your appliance must be mounted on a flat surface
for the full width and depth of the product.
infill panel
20mm
16mm cleat
cupboard doorcupboard door
Figure A - flush fit (top view)
600mm
cupboard front
Figure B - proud fit (top view)
565mm
INSTALLING YOUR APPLIANCE
Loading ...
Loading ...
Loading ...