Loading ...
Loading ...
Loading ...
ENGLISH
5
Fig. K2
4
• If using a bag filter, twist the two pieces back together
after they have fully dried.
• Place filter back into the bowl pressing firmly to ensure
a secure fit.
• To replace dust bowl, place it back onto the handle until it
“clicks” firmly into position.
IMPORTANT: Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
• Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
• It is very important that the filter is correctly in position
before use.
Nozzle / Accessories (Fig. L–O)
• Figure L - A crevice tool
6
is built into the nozzle and
can be extended as shown in Figure L by pulling the
extension piece until it locks into position.
• To store the crevice tool
6
into the nozzle press the
stopping rib
12
and then push the crevice tool
6
into
the nozzle until it locks into position.
Fig. L
6
12
• Figure M - A brush accessory
5
is built into the nozzle
and can be flipped upwards for use.
5
Fig. M
Scented Filter*
BEFORE FIRST USE - Remove bag from the scented pre-filter.
Reassemble per instructions above.
When the vacuum is turned on, the plastic scented filter will
emit an aroma to freshen the air.
WARNING:
- Causes mild skin irritation
- Toxic to aquatic life
- Harmful to aquatic life with long lasting effects.
- Dispose of contents/ containers to an approved
waste disposal plant.
NOTE: When the plastic scented filter no longer lets off
the aroma, it can be an indication that the filter needs to be
replaced. See below for information on replacement filters.
*HLVA320JS vacuums are supplied with a scented filter,
though any vacuum covered in this manual can accept a
scented filter.
Replacing the Filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.
WARNING: Make sure the vacuum is
completely dry before using it.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service organizations,
always using identical replacement parts.
Troubleshooting
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It
feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly
attached.
• The charger is plugged into a working electrical outlet.
• The switch is in the “OFF” position when charging.
For assistance with your product, visit our website
www.blackanddecker.com for the location of the service
center nearest you or call the BLACK+DECKER help line at
1–800–544–6986.
ACCESSORIES
Recommended accessories for use with your appliance are
available from your local dealer or authorized service center.
Loading ...
Loading ...
Loading ...