Loading ...
Loading ...
Loading ...
10
Robert Bosch Hausgeräte GmbH
en
Problem Possible cause Remedy
The temperature of the water
drawn is too low.
The temperature set displays the
water temperature directly at the
water outlet.
Select a higher temperature.
The glass or cup is too cold. Rinse out the glass or cup with hot
water before lling it or draw water
rst to heat it up.
There is a build-up of limescale
in the appliance.
Descale the appliance as
described in the instructions.
With extremely calciferous water,
descale the appliance more often
than the symbol is displayed.
Water is collecting in the water
outlet.
Condensation water may result
due to physical properties.
It is normal for condensation to
appear, simply wipe it away.
The O symbol is lighting even
though there is a sufcient
amount of water in the water
tank.
The oat in the water tank is
stuck.
Clean the water tank and release
the oat.
N
lights up after only a few
drawing cycles.
Possible operating error. Descale the appliance as
described in the chapter
“Descaling”.
N lights up even though a lter
has been used.
Even ltered water contains low
amounts of calcium carbonate.
Descale the appliance as
described in the chapter
“Descaling”.
N lights up even though the
appliance has just been
descaled.
The descaling programme was
interrupted because of, for
example, too little water or a
power failure.
Carry out the descaling programme
again as described in the chapter
“Descaling”.
Loud “cooking and pumping”
noises are heard during the
drawing process.
The lter is set to “yes” (see
chapter “ BRITA MAXTRA
water lter system”) but there
is no lter in place. Build-up of
limescale in the appliance.
Descale the appliance as
described in the chapter
“Descaling”.
Finally, programme the correct
setting.
The used water is particularly
calciferous. Build-up of
limescale in the appliance.
The appliance must be descaled
more often than the N symbol lights
up. Follow the instructions outlined
in the chapter “Descaling”.
N, M and O are all ashing at
the same time, it is not possible
to draw any water.
The appliance has a fault. Disconnect the appliance from
the power supply and contact
Customer Service.
If you are unable to rectify the problem, please contact Customer Service.
Technical data
Power connection (voltage/frequency) 220-240 V / 50 Hz
Heater wattage 1600 W
Maximum static pump pressure 3.3 bar
Maximum water tank capacity (without lter) 2 litres
Length of power cable 80 cm
Dimensions (H x W x D) 290 x 223 x 267 mm
Weight, empty 2.3 kg
Loading ...
Loading ...
Loading ...