Loading ...
Loading ...
Loading ...
20060601
7-1
Error Messages
7. Error Messages
Attempting to perform some inappropriate operation in the Geometry Mode will cause one of
the error messages described below to appear. Use this table as a reference to find out what
you need to do when an error message appears.
When you see
this message:
It means this: So you need to do this:
First select a
segment.
You are attempting to construct a
perpendicular bisector without first
selecting a line segment.
Select the required object(s) and
then try again.
First select a
line and point.
You are attempting to construct a
perpendicular or parallel without
first selecting a line segment and
point.
First select
2 points or a
segment.
You are trying to construct a
midpoint without first selecting two
points or a line segment.
First select
the applicable
figure.
• You are trying to construct a You are trying to construct aYou are trying to construct a
point of intersection without first
selecting two lines.
• You are trying to execute an Add You are trying to execute an AddYou are trying to execute an Add
Animation or Replace Animation
command without first selecting
the required object.
• You are trying to execute an Add You are trying to execute an AddYou are trying to execute an Add
Table command without first
selecting the required object.
First select 2
segments.
You are trying to construct
an angle bisector without first
selecting two line segments.
Too Many
Objects! Work
memory cleared.
Work memory became full. Delete objects you no longer need
or open a new file.
Invalid
Measurement
You are attempting to use the
Expression command to input
an expression that contains a
measurement that does not exist.
Check to make sure that the
expression you are inputting
contains only measurements that
are currently on the screen.
Loading ...
Loading ...
Loading ...