Loading ...
Loading ...
Loading ...
9
• Lift the removable water tank (located at
the front of the steam station) pressing on
the lock screw located on the tank handle
– fig. 4.
• Fill the tank with untreated tap water,
taking care not to exceed the maximum
level - fig. 5.
• Slide the tank back into its housing until it
“clicks” into place.
• Unwind the electrical power cord it
completely and remove the steam cord
from its housing- fig.6.
• Plug your steam station into a 120 volt
electric outlet - fig.7.
USE
4 • Switching on your steam
station
• Press on the on / off switch - fig. 8, it
begins flashing. The green light located
on the control panel flashes
• When starting, and regularly while it is
being used, your steam station's electric
pump injects water into the boiler. It makes
a noise but this is quite normal.
•
The steam station and the iron are ready for
use when the steam indicator light is on and
the iron light goes out.
5 • Operating the control
panel
•
Flashing green light -
fig. 8
: the water is
heating up in the boiler.
•
Continuous green light -
fig. 10
: steam is
ready for use.
•
Flashing red light -
fig. 13
: the tank is
empty.
• The
“Calc Away System” or the “boiler
rinse" orange indicator flashes -
fig. 15 or
fig. 21
(according to model) : the collector /
boiler needs to be rinsed.
6 • Using your steam station
• Place the iron’s temperature control - fig.
9 to the type of fabric to be ironed (see
table below).
• The iron temperature control light turns
on. Important: whenever you start using
your iron and whenever you reduce the
temperature during use, the iron is ready
for use when its indicator light goes out
and when the green light located on the
control panel comes on and remains on.
• During use, when you increase the
temperature of the iron, you can start
ironing immediately.
• ECO Mode: Your steam
station has an ECO mode function which
uses less power whilst still guaranteeing a
sufficient steam output for you to iron your
garments properly.
In order to use this function, once the
thermostat of your iron has been correctly
set (see table above), press on the ECO
button located on the control panel.
The ECO mode can be used on all types of
fabrics, nevertheless for very thick or very
creased fabrics we recommend that you
deactivate ECO mode (by pressing the
ECO button again) to guarantee the best
results.
• During ironing the iron indicator light
switches on and off according to heating
requirements but this has no effect on
use.
• To obtain steam, press on the steam
control button beneath the iron handle
and keep it pressed - fig. 11. The steam
will stop when you release the button.
• Always spray starch on the reverse side of
the fabric to be ironed.
The first time the appliance is used,
there may be some fumes and a slight
smell this is not harmful and will quickly
disappear.
TYPE OF FABRIC
SETTING
TEMPERATURE
SYNTHETICS
(Polyester, Acetate, Acrylic, Polyamide)
•
SILK / WOOL
• •
COTTON / LINEN
• • •
EN
1800133852 DG8510-20 U0_110x154 26/06/14 15:28 Page9
Loading ...
Loading ...
Loading ...