Liebherr CS2092 36 Inch Built-In French Door Refrigerator with 19.5 cu. ft. Total Capacity, DuoCooling, SuperFrost, SuperCool, LED Lighting, NoFrost, Door Alarm, IceMaker, Star-K Certified, and Sabbath Mode

User and Care Manual - Page 11

For CS2092.

PDF File Manual, 28 pages, Read Online | Download pdf file

CS2092 photo
Loading ...
Loading ...
Loading ...
11
operaTion
Temperature Display - Figure 8
In normal operation, the following settings will be
displayed:
the average refrigerator temperature
the warmest frozen food temperature.
When starting up for the first time or when
the appliance is warm, dashes will appear
in the freezer temperature display, until the
temperature in the freezer compartment is
32°F (0°C).
It will take between three and eight hours for the
required temperature, 0°F or 38°F (-18°C or 3°C) to
be reached and displayed permanently in the display,
depending on the ambient conditions and the tempera-
ture setting.
The display will flash:
if you change the temperature or
if the temperature rises by several degrees, indicating
cold loss, e.g. if you place fresh, “warm” food in the
freezer or if you remove or repack frozen food, the
temperature may rise for a short time due to warm air
flowing into the freezer.
If “F1” to “F5” appears in the display, the appliance
has a fault. Have the fault number available when you
contact the customer service department.
Audible Alarm Signal - Figure 8
The audible alarm signal helps to protect frozen food
and to save energy.
The audible alarm signal is switched o by touching
the alarm icon.
Audible door alarm
This sounds when the door has been left open for
longer than about 180 seconds. The sound switch-
o function is active as long as the door is left open.
The alarm automatically switches back to standby
when the door is shut.
Audible/visual temperature alarm
It always sounds if the freezer temperature is not
low enough. The temperature display and the alarm
LED
ashes at the same time.
This can be caused by:
- warm, fresh food being placed in the freezer;
- too much warm air from the outside entering
when re-arranging or removing frozen food,
- a fault in the appliance.
The temperature display will continue to ash until
the cause of the alarm has been rectied. It will then
stop ashing and light up continually. The audible
warning signal is now automatically reset.
Power Failure/Frost-Control Display -
Figure 8
If the power failure LED is lit, this means the freezer
temperature has risen too high during the last few hours
or days due to a power failure. The freezer temperature
display flashes at the same time.
If you touch the Alarm icon now, the highest tem-
perature registered during the power failure will be
displayed.
Check the quality of the food in case it has become
too warm or even defrosted.
The highest temperature will appear for approximate-
ly one minute. After that, the actual temperature in the
freezer will reappear.
The display can be turned off by touching the Alarm
icon again.
Supercool - Figure 8
Touching the Supercool icon switches the refrigerator
compartment to maximum cooling. It is recommended
particularly if you wish to cool large quantities of food,
drinks, freshly baked goods or meals rapidly.
Turning on: Touch the Supercool icon briefly so the
LED
turns on. The refrigerator temperature will
drop to its lowest value.
IMPORTANT
The Supercool function uses slightly more
energy. After approximately six hours, however,
the refrigerator switches back automatically to
normal energy-saving operation. If required, the
Supercooling function can be turned off sooner.
Turning off: Touch the Supercool icon again until the
LED
turns off.
Loading ...
Loading ...
Loading ...