Tripp Lite BHDBT-K-SI-ER Owner's Manual

Loading ...

RS-232 Serial Control (Matrix Transmitter Units Only)

Before using RS-232 serial control, you must first access Terminal Emulation Software

and update the COM port settings.

2. Select the COM port that is being

used and update the remaining

settings: Baud Rate (57600), Data (8

bit), Parity (none), Stop (1 bit), Flow

Control (none).

1. Go to the Setup drop-down menu and

select the Serial Port option.

3. Next, you will need to configure your

software to allow input control. Go to

the Setup drop-down menu and select

the Terminal option.

4. Update the following settings: Receive

(LF), Local Echo (enable). The other

settings can remain unchanged.

5. Once these settings are updated, the Terminal Emulation Software will recognize the

switch. Upon recognition, you will be able to enter commands to control the unit.

The available commands are listed as follows:

Command Action

sw[x] [n] Switches the source being displayed on the selected output. [x] is the output (1,

2, 3, or 4) and [n] is the desired source (A, B, C, or D). For example, a command

of sw1 A would display source A on output 1.

PWD Turns power to the switch on/off.

STE Displays the current output state, showing which source is being displayed on

each output.

18-11-133-933418-EN.indd 13 11/15/2018 10:35:35 AM

Loading ...

Tripp Lite BHDBT-K-SI-ER HDBaseT HDMI Over Cat5e/6/6a Extender Kit