Loading ...
Loading ...
Loading ...
73
NOTE
1. If the IDs of the original sensor and the new MX-Sensor are the same and the ID is
already registered to the vehicle ECU, there is no need to perform the Relearn
function when the new programmed sensor has been installed to the same wheel.
3. If the IDs retrieved from sensor activation and those registered to the TPMS ECU
are different, tap Copy by OBD to program the IDs saved in the ECU to the new
MX-Sensor.
6.6.2 Copy by OBD
By using this function, the tablet will program the sensor IDs retrieved from the ECU of
the test vehicle to the new MX-Sensors.
To copy by OBD
1. Select one sensor position and place a MX-Sensor near the TPMS antenna of
the tablet (the top-right corner), then tap Copy by OBD to program the new
MX-Sensor.
Figure 6-29 Copy by OBD Screen
2. When the programming is complete, the programmed ID will display in the
column to the right of the wheel designation. In the pictured example, the new
ID is displayed to the right of the RF column.
NOTE
1. There is no need to perform the Relearn function to write the ID into the ECU when
the new programmed sensor has been put in the same position.
2. The Copy by OBD programming method, if available, is recommended to program
new MX-Sensors.
Loading ...
Loading ...
Loading ...