Loading ...
Loading ...
Loading ...
31
EN
The appliance asks to be
unplugged and plugged back in
again.
Unplug the appliance for 20 seconds, remove the Claris Aqua Filter System
cartridge if necessary, then plug it back in again.
If the error continues, contact the KRUPS Customer Service team.
The machine does not request
descaling.
The descaling cycle is requested after the steam circuit has been used a
signicant number of times.
Some ground coffee has found
its way into the drip tray.
A small amount of ground coffee may settle in the drip tray. The machine is
designed to evacuate any excess ground coffee so that the percolation zone
remains clean.
The milk or water is not owing
correctly into the cup(s).
Check that the One Touch Cappuccino block is correctly positioned.
There are traces of milk in an
Americano or a Hot water.
Complete a milk rinsing cycle or dismantle and clean the one touch cappuccino
accessory before running the preparation.
There is water underneath the
appliance.
Before removing the water tank, wait for 15 seconds after the coffee has
nished owing so that the appliance nishes its cycle properly. Check that the
drip tray is correctly positioned on the machine; it should always be in place,
even when the appliance is not in use. Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
When you turn off the appliance,
warm water ows out of the
coffee outlets and the One Touch
Cappuccino block.
According to the type of recipe prepared, the machine may run an automatic
rinsing cycle when it is turned off. This cycle lasts only a few seconds and stops
automatically.
After emptying the coffee
grounds collector, the warning
message is still displayed on the
screen.
Correctly replace the coffee grounds collector and follow the instructions on
the screen.
Wait at least 5 seconds before replacing them.
The coffee dispenses too slowly.
Turn the ‘neness of grind’ adjustment dial to the right to make the ground
coffee coarser (according to the type of coffee used).
Run one or several rinsing cycles.
Run a machine clean (see “Automatic machine cleaning programs p.28).
Change the Claris Aqua Filter System cartridge (see “Installing the lter”) p. 23).
The water tank has been lled,
but the warning message is still
displayed on the screen.
Check that the tank is installed correctly on the device.
The oat at the bottom of the tank should move freely. Check and unblock the
oat if necessary.
The coffee neness knob is
difcult to turn.
Only change the grinder setting when it is running.
The espresso or coffee is not hot
enough.
Run a coffee circuit rinsing cycle before preparing your coffee.
Increase the coffee temperature in the Settings menu. Warm the cup by rinsing
it with hot water before making the drink.
The coffee is too lightly coloured
or too weak.
Avoid using oily, caramelised or avoured coffee beans. Check that the coffee
bean container has coffee in it and that is it dispensing correctly.
Decrease the volume of the preparation and increase the strength of your drink
by using the Dark function.
Turn the grinding neness adjustment dial to the left to make the grounds ner.
Make the drink in two cycles by using the 2 cups function.
Loading ...
Loading ...
Loading ...