Loading ...
Loading ...
Loading ...
Navigating Between Modes
Press (C) to cycle between modes.
●
Holding down (C) for at least four seconds
in any mode enters the Timekeeping Mode.
CC
C
C
World Time Mode
Countdown Timer Mode
Timekeeping Mode
Stopwatch Mode
Alarm Mode
C
Auto-return
While a time or other setting screen is
displayed (digital display flashing), the watch
will exit the setting screen automatically after
about two or three minutes of non-operation.
High-speed Scrolling
In all modes, (B) and (D) are used to change
the currently selected setting. Holding down
(B) or (D) scrolls through settings at high
speed.
Cycling Between
Timekeeping Mode Digital
Display Contents
Each press of (A) in the Timekeeping Mode
cycles display contents as shown below.
A
Hour, minute
Month, day
Shifting the Hands
Hand shift moves the hands out of the way for
easy viewing of display information.
1. Hold down (C) for at least two seconds.
Release the button when [HAND] appears
on the display.
●
This will shift the analog hands to allow
easy viewing of display information.
2. Hold down (C) for at least two seconds
again. Release the button when [HAND]
appears on the display.
This returns the hands to their normal
timekeeping positions.
Note
●
If you leave the watch with its hands
shifted and do not perform any
operation for about one hour, the
hands will resume normal timekeeping
automatically.
●
The hands will shift automatically
whenever you display a setting screen
while in the Timekeeping Mode,
Countdown Timer Mode, or Alarm
Mode. They will automatically return to
their normal timekeeping positions
when you exit the setting screen.
However, if the hands were already
shifted before you displayed the
setting screen, they will remain shifted
when you exit the setting screen.
Solar Charging
This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
●
Charging the Watch
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
light by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
NOYES
Important!
●
Depending on light intensity and local
conditions, the watch may become hot
to the touch when exposed to light for
charging. Take care to avoid burn
injury after charging. Also, avoid
charging the watch under high-
temperature conditions like the ones
described below.
ー
On the dashboard of a vehicle
parked in the sun
ー
Near an incandescent light bulb or
other source of heat
ー
Under direct sunlight or in other hot
areas for long periods
●
The display panel may become black
under very high temperatures. This is
temporary, and the display will return
to normal at lower temperatures.
Watch Operation Guide 5550
6
Loading ...
Loading ...
Loading ...