Operating Instructions
Micathermic Heater
Model: GMH150
General Care and Safety Guide
Thank you for choosing a Goldair Micathermic Heater. This Goldair Heater
has been designed and manufactured to high standards of engineering
and with proper use and care, as described in this leaflet, will give you
years of useful service. Please read these instructions carefully.
1. Use only the voltage specified on the rating
label of the appliance.
2. Keep all objects at least 1 metre from the
front, sides and rear of the appliance. Do not
place appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this
may cause an electric shock, fire or damage
to the appliance. Do not sit on the appliance.
5. Do not operate this appliance with a
damaged cord, plug or after the appliance
malfunctions or has been dropped or
damaged in any manner. Return to a
qualified electrical person for examination,
electrical service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended
by the manufacturer and may cause fire,
electrical shock or injury.
8. The common cause of overheating is
deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly
by unplugging the appliance and vacuum
cleaning the air vents and grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always
remove plug from the mains supply before
cleaning.
10.Do not connect the appliance to mains supply
until completely assembled and adjusted.
11.Switch off and use handles provided when
moving.
12.Do not operate with cord set coiled up as a
heat build up is likely, which could be
sufficient to become a hazard.
13.The use of an extension cord with this
appliance is not recommended.
14.Do not remove plug from power socket until
the appliance has been switched off.
15.Do not remove plug from power socket by
pulling cord; always grip plug.
16. Always unplug appliance when not in use.
17. Do not locate the heater directly below any
power socket during operation.
18. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage area
and is unrolled before use.
19. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge, unless they are
supervised or have been given instruction
concerning the use of the appliance by a
person responsible for their safety.
20. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not
be immersed in any liquids.
21. When the appliance has been unpacked,
check if for transport damage and ensure all
parts have been delivered. If parts are missing
or the appliance has been damaged, contact
the Goldair Customer Services Team. (refer to
details on back page)
22. If your appliance does not work, or is not
working properly, contact the place of
purchase or the Goldair Customer Services
Team. (refer to details on back page). Repair
work on the appliance by unqualified persons
can cause serious risk to the user.
23. There are no user serviceable parts installed in
the unit.
24. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire
hazards.
25. This unit is not supposed to be used in or
around locations where foodstuffs, works of art
or delicate articles of science, etc are stored.
26. Indoor use only.
27. Children should be supervised to ensure that
they do not play with the appliance.
28. Ensure heater is on a flat, stable, heat-
resistant surface.
Overview of your Micathermic Heater
Micathermic heating uses both radiant and convection heating
technology. Natural convection currents distribute the heat evenly
throughout the room, while radiant heat from the heating surface warms
people and objects in the room. This heater is equipped with two manual
heat settings and an adjustable thermostat.
1. Heater
2. Control Panel
3. Front Panel
4. Wheel Bracket
5. Wheel
FEET ASSEMBLY
3
2
5
1
4
1. Power indicator light
2. Power Switch I
3. Power Switch II
4. Thermostat
1
3
2
4
1
Fixing
Screw
Castor
Spring
Gasket
Flat
Gasket
Wheel
Bracket
Wheel
Bracket
Flat
Gasket
Spring
Gasket
Standard
Screw
Heater
PICTURE A
PICTURE B
Install castor
Take out four castors, two wheel brackets,
four fixed screws, four flat-gasket of 4mm diameter,
four spring-gasket of 4mm diameter from list.
According to picture A, Firmly install castor on
wheel bracket.
Install wheel bracket
Take both wheel-brackets once castors installed,
take two Standard Screws, two flat-gasket of 5mm
diameter, two spring-gasket of 5mm diameter.
According to picture B, firmly install wheel-bracket on
the bottom of the Heater.
Parts Included
TECHNICAL SPECIFICATION
Model No: GMH150
Power Supply: 220-240V, 50Hz AC only
Power: 2000W
Title
Quantity
Comments
Heater
1
Wheel Bracket
2
Castors
4
Fixing Screws
4
Use for fixing
Castors
4mm Flat Gasket
4
4mm Spring Gasket
4
Standard Screw
2
Use for fixing Wheel
Bracket
5mm Flat gasket
2
5mm Spring Gasket
2
Operating
Instructions
1
Operating your Micathermic Heater
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday – Friday 8am-5pm
Phone: 0800 232 633
Website: www.Goldair.co.nz
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate operating
position.
The second device, automatically disconnects &
reconnects the appliance at a preset temperature.
The third device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse. (It is non resettable)
IMPORTANT! NEVER COVER THIS HEATER!
Covering the heater will cause activation of the non
resettable safety fuse.
CARE AND CLEANING
Do not attempt to dismantle the Micathermic Heater.
There are no user serviceable parts. For service or
repair, contact an authorised electrical service
technician. The outer shell may be cleaned with a
soft, damp cloth. You may use a mild detergent if
necessary. After cleaning, dry the unit with a soft
cloth. CAUTION: DO NOT let liquid enter the heater.
CAUTION
The Micathermic Heater generates heat during use.
Proper precautions must be taken to prevent the risk
of burns, scalds, fires or other damage to persons.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
HEAT CONTROL SWITCH
The control switch positions are:
0 OFF
I Low Heat
II High Heat
Check that the heat control switch is set to off
position before plugging the heater into the
mains supply. For greater economy, use the
high heat setting initially and then switch to
the low heat setting.
THERMOSTAT
Turn the thermostat knob clockwise until the
maximum temperature is obtained on the
graduated scale. When the desired
temperature is reached, slowly turn the knob
anti-clockwise until the heater turns off (you
will hear a click). The heater will now cycle on
and off to maintain the set temperature.
CAUTION: never install the heater directly
beneath a socket-outlet or in such a way that
people in the baths, showers or pools may
have to touch live parts such as a switch.
Important: The radiator must be connected to
an earthed outlet of the appropriate voltage.
Note: When the heater is turned on for the
first time, it may release a slight, odour or
smoke. This odour or smoke is a normal
occurrence caused by the initial heating of the
internal heating elements and should not
occur again.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
WARNING: THIS IS A DOUBLE SIDED HEATER. Keep all objects at least 1
metre from the front, sides and rear of the appliance.
Your Goldair product has been inspected and
tested and is guaranteed subject to the
following for a period of two years from the
date of purchase against defects in
workmanship and materials. During this
period, such defects will be rectified by repair
or replacement of the product purchased.
Your product contains no user serviceable
components and this warranty becomes
invalid if in our opinion the product has been
misused, abused, incorrectly installed,
tampered with, connected to an electrical
supply not corresponding with the name plate
specification, or subjected to power surges.
The warranty does not include any labour or
other associated expense that may be
involved in removal or installation of the
product. Normal wear and tear is expressly
excluded.
If your Goldair product fails to operate
satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a
repair or replacement product under this
warranty, you will need to produce satisfactory
evidence of date of purchase. The completed
warranty and purchase receipt must be
presented with the product. The warranty
should be filled out at the time of purchase. It
is in your interest to make sure this is done.
If the product is to be replaced (cannot be
repaired) then that replacement will be of the
same or similar product or accessory
excluding packaging, instruction card etc.
Where a replacement product is supplied, this
shall be guaranteed for the balance of the
original warranty period.
Any model that is no longer available will be
replaced by a model of a value and with such
features as we consider appropriate in the
circumstances. Goldair is not responsible for
freight forwarding charges, losses or damage
in transit.
If service is required after the warranty period
has expired, the product should be returned to
a qualified electrical technician. Service
outside of the warranty period will be at your
cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers
are advised that: The manufacturer does not
undertake that repair facilities and parts are
necessarily available for this product.
If any of the provisions of the foregoing are
contrary to any relevant legislation, then that
provision shall be deemed to be excluded from
the warranty and the rest of the provisions will
continue to apply.
Name ………………………………………………
Address ……………………………………………
……………………………………………………….
Suburb ……………………………………………
Purchased from …………………………………
Date of purchase …………………………………
Name of product …………………………………
Model no ……………………………………………
IMPORTANT: Please retain this warranty card
Two Year Warranty
