Loading ...
Loading ...
Loading ...
8
WARNING! Failure to install the
screws or fixing device in accordance
with these instructions may result in
electrical hazards.
• Do not use or leave the hood without
the lamp correctly mounted due to the
possible risk of electric shocks.
• Never use the hood without effectively
mounted grids.
• The hood must NEVER be used as a
support surface unless specifically
indicated.
• Use only the fixing screws supplied with
the product for installation or, if not
supplied, purchase the correct screws
type.
• Use the correct length for the screws
which are identified in the Installation
Guide.
• In case of doubt, consult an authorized
service assistance center or similar
qualified person.
WARNING! Do not use with a
programmer, timer, separate remote
control system or any other device that
switches on automatically.
Electrical connection
The mains power supply must
correspond to the rating indicated on the
plate situated inside the hood. If provided
with a plug connect the hood to a socket
in compliance with current regulations
and positioned in an accessible area,
after installation. If it not fitted with a plug
(direct mains connection) or if the plug is
not located in an accessible area, after
installation, apply a double pole switch in
accordance with standards which
assures the complete disconnection of
the mains under conditions relating to
over-current category III, in accordance
with installation instructions.
WARNING! Before re-connecting the
hood circuit to the mains supply and
checking the efficient function, always
check that the mains cable is correctly
assembled.
The hood is provided with a special
power cable ; if the cable is damaged,
request a new one from Technical
Service.
Installation
• The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
50cm from electric cookers and 65cm
from gas or mixed cookers.
If the instructions for installation for the
gas hob specify a greater distance, this
must be adhered to.
Applying kitchen utensil rack
Attention! The kitchen utensil rack is an accessory that can
be applied on certain models only. Fig. 20.
• This appliance is marked according to the European
directive 2012/19/EC - UK SI 2013 No.3113 on Waste
Electrical and Electronic Equipment (WEEE).
• By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
• The symbol
on the product, or on the documents
accompanying the product, indicates that this appliance may
not be treated as household waste. Instead it should be taken
to the appropriate collection point for the recycling of electrical
and electronic equipment. Disposal must be carried out in
accordance with local environmental regulations for waste
disposal.
• For further detailed information regarding the process,
collection and recycling of this product, please contact the
appropriate department of your local authorities or the local
department for household waste or the shop where you
Loading ...
Loading ...
Loading ...