Loading ...
Loading ...
Loading ...
15. Motion Drive Belt Removal
Thetractordrivebeltmaybereplacedwithouttools Parkthe
tractor on level area, Engage parking brake, NOTE: A BELT
INSTALLATION DECAL IS UNDER LEFT FOOTREST
ao Remove mower, (See mower section, page 20),
CLUTCH
AND ADJUSTMENT
ENGINE
PULLEY /
ELT
INSTALLATION
DECAL
b. Remove two retainer springS from be# guide bracket
below transaxle pul/ey. Remove bracket (Fig. 21)o
c. Swing belt guides away from belt, toward rear of
tractor (Fig.. 21).
cL Roll bell over top of transaxle pulley,
e. Roll bell over engine pulley and off idler (Fig. 22).
L Release parking brake° Puff belt as far as possible
over top of clutch pulley..
g. Reset parking brake. Pull belt over top of clutch
pulley (Fig.. 22).
h. Pull belt out through shift gate to remove from tractor
(Fig. 23).
Install belt by reversing above procedure.
NOTE: REPLACE ONLY WITH BELT LISTED IN MANUAL
BELT
GUIDE_
TRANSAXLE
PULLEY
LH. SIDE
BELT GUIDE
REAR
VIEWED FROM BOTTOM OF TRACTOR
FIGURE 22
BELT
SHIFT GATE
_GURE 23
f l
RETAINER BELT GUIDE RETAINER
SPRING BRACKET SPRING
FIGURE 21
19
Loading ...
Loading ...
Loading ...