Loading ...
Loading ...
Loading ...
12 English
Depending on the equipment variant, a
non-woven filter bag is included. Al-
ways use the filter bag in addition to the
non-woven filter bag when dry vacu-
uming.
Filter bag
Note
Regularly replace the filter bag when
full as a filter bag that is too full could
be damaged. The filling level of the fil-
ter bag depends on the dirt being vac-
uumed. The filter bag should be
replaced more often in the case of fine
dust, sand, etc.
Note
Filter bag order no.: 2.863-014.0.
Wet vacuum cleaning
ATTENTION
Wet vacuuming with a filter bag
Device damage
Do not use a filter bag when vacuum-
ing wet debris.
ATTENTION
Operation with full container
When the container is full, the float
switch closes the suction opening and
the device runs at a higher speed.
Switch off the device immediately and
empty the container.
Note
If the device falls over, the float can al-
so close. Set up the device, switch it
off, wait 5 seconds and then switch it
on again.
Depending on the equipment variant, a
foam filter is included.
Note
Ensure the firm seating of the foam fil-
ter.
Blower function
The blower function can be used to
clean areas that are difficult to reach or
where vacuuming is not possible, e.g.
leaves in a gravel bed.
Insert the suction hose into the blow-
er connection. The blower function
is now activated.
Interrupting operation
1. Set the trigger to "0 (OFF)".
The device is switched off.
Finishing operation
1. Set the power switch to "0/OFF".
The device is switched off.
2. Pull out the plug.
3. Remove the device head.
a.
b.b.b.
a.
a.
b.
Loading ...
Loading ...
Loading ...