Loading ...
Loading ...
Loading ...
354
PO
SAVE THESE INSTRUCTIONS
(354PO) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 04/10/2022
English
Page 10
SAND FILTER PUMP HOSE CONNECTION SETUP
The 4-way valve has three hose connection ports.
1.
Connect one hose
(12)
end to the pump motor inlet and the other end of the hose to the
lower connector with the strainer. Ensure the hoses are securely tightened.
2.
Connect the second hose
(12)
between the 4-way valve water outlet and the upper
connector with the inlet-nozzle. Ensure the hoses are securely tighten.
3.
The third hose connection port (drain/waste outlet) on the 4-way valve shall be directed to
a proper draining receptacle using a hose or pipe (not provided). Make sure the drain outlet
cover is removed before attaching the drain/waste hose or pipe.
4.
The sand filter pump is now ready to filter the pool.
WARNING
• Position this product away from the pool, so as to prevent children from climbing
on it and accessing the pool.
(ILLUSTRATION NOT TO SCALE)
Long hose
Short hose
For Pools with Dual Suction Outlets Configuration:
In order to comply with the requirement of the Virginia Grahame Baker Act (for USA and
Canada), your pool is designed with dual suction outlets and one inlet fittings. Parts in grey
highlight on this page are supplied with the pool set package and are shown here for assembly
purposes only. If this pump was purchased as part of a pool set, refer to the pool owner’s
manual for more details.
WATER INLET
WATER LEVEL
OUTSIDE
LINER WALL
HOSE
O-RING
WATER
OUTLET
TO
DRAIN
AIR RELEASE
VALVE
AIR JET VALVE
POOL INLET AIR
ADAPTOR
HOSE
CLAMP
20 23
20 21
Loading ...
Loading ...
Loading ...