Loading ...
Loading ...
Loading ...
Configuring Interval Timer Settings
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
3. Use (E) and (B) to specify the number of
timer repeats.
4. Press (D).
5. Use (E) and (B) to specify the position of
the timer in the sequence.
●
To specify the first position, set [1].
6. Press (D).
This causes the minutes digits of Timer 1
to flash.
7. Use (E) and (B) to change the minutes
setting.
Minutes
8. Press (D).
This causes the seconds digits of Timer 1
to flash.
9. Use (E) and (B) to change the seconds
setting.
Seconds
10. Press (D) twice.
This returns to the screen in step 5.
11. Repeat steps 5 through 10 as many times
as necessary to configure the settings of
other timers.
12. Press (A) to complete the setting
operation.
Note
●
You can also use G-SHOCK MOVE to
configure programmable timer
settings.
Using a Interval Timer for Elapsed
Time Measurement
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Press (E) to start the timer countdown.
The watch beeps every second for the last
five seconds of the current countdown,
and starts the countdown of the next timer
when the end is reached.
●
To pause an ongoing timer countdown,
press (E). You can reset a paused
countdown to its start time by pressing
(A).
●
When there is a multiple timer
countdown operation in progress, you
can terminate the current countdown
and start the next countdown by holding
down (A) for at least 0.5 seconds.
Checking the On/Off Status of
Programmable Timers
In the Timer Mode, you can find out if each of
the programmable timers is turned on or off by
checking Graphic Indicator B.
The current status of a programmable timer is
indicated by whether the indicator segment of
the program number is displayed, flashing, or
not displayed.
Graphic Indicator B
Program 1
Program 2
Program 3
Program 4
Program 5
Programmable timer status Graphic
Not programmed Not displayed
Programmed Displayed
Operation in progress/Auto
Start
Flashing *
Paused
Flashing
Timer settings being
configured
* Segment disappears when the program is
complete.
Example Display
Program 1, 2, 4: Programmed
Program 3, 5: Not programmed
Program 2: Timer countdown operation in
progress
Not programmed
Timer countdown operation in progress
Programmed
Watch Operation Guide 5641
19
Loading ...
Loading ...
Loading ...