Loading ...
Loading ...
Loading ...
English
9
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
WARNING: To reduce the risk of serious personal
injury, always wear ANSI compliant eyeprotection.
Assembling the Dust Port (Fig. D, E)
(Optional Accessory)
1. Fully loosen depth adjustment lever (
4
, Fig. D).
2. Align the dust port–back half
19
over upper blade
guard
20
as shown. Be sure to insert the tab
21
into
the casting notch on the tool as shown in FigureE.
When installed correctly, it will snap fully over the
original depth of cutpointer.
3. Align the dust port
22
with the dust port–back
half
19
.
4. Insert two dust port screws
23
as shown and
tightensecurely.
Fig. D
20
4
6
19
22
23
23
Fig. E
21
21
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Installing and Removing the Battery Pack
(Fig. F)
nOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack
3
into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does notdisengage.
To remove the battery pack from the tool, press the release
button
13
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of thismanual.
Fig. F
13
3
Loading ...
Loading ...
Loading ...