Loading ...
Loading ...
Loading ...
7 — English
Align the tabs on the blower inlet with the notches on the
rear port and slide together.
Lift and rotate the mode selector to the blower position
to lock the blower inlet in place.
Install lower tube and speed tip as described later in this
section.
INSTALLING THE LOWER TUBE
See Figures 5 - 6.
With the tab facing down, slide the lower tube over the
upper tube on the motor housing.
Push the lower tube on the upper tube until the tab locks
into place through the notch in the motor housing.
NOTE: The lower tube must be fully locked into place or
the tool will not operate.
To remove the tube, depress the tab and slide tube off.
To install the speed tip or vacuum nozzle: Align the tab
on the speed tip or nozzle with the notch on the lower
tube and press together until the tab locks into place.
To remove the speed tip or vacuum nozzle: depress
the tab and slide off the speed tip or nozzle.
NOTICE:
When correctly assembled, the tube is difficult to sepa-
rate. If it can easily be pulled apart, the tube is not locked.
Check that the tab is aligned, and push the lower tube on
to the motor housing until the tube snaps into the locked
position. If the tube is not in the locked position, it can
separate during operation.
CONNECTING AND ADJUSTING THE
SHOULDER HARNESS
See Figures 7 - 8.
The shoulder harness is recommended when vacuuming.
Straps should be adjusted to a comfortable position before
starting the blower/vacuum.
Slip arm through harness strap and onto shoulder, then
repeat for the other shoulder.
Connect the waist straps and adjust for comfort.
Adjust the shoulder straps until the harness rests com-
fortably against the small of the back.
Once the harness is in a comfortable position, connect
the harness to the strap hangers on the blower/vacuum.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
ASSEMBLING THE TOOL
See Figures 2 - 4.
WARNING:
Contact with rotating impeller blades could result in seri-
ous personal injury. Always remove the battery pack and
make sure impeller blades have stopped rotating before
installing the blower inlet or leaf collection bag. Do not
put hands or any other object into the vacuum tubes while
they are installed on the unit.
This tool can be assembled for vacuum or blower operation.
To assemble the tool for vacuuming:
Remove the battery pack.
If applicable, lift and rotate the mode selector to the center
(unlocked) position then remove the blower inlet from the
rear port.
Align the tabs on the leaf collection bag with the notches
on the rear port and slide together.
Lift and rotate the mode selector to the vacuum position
to lock the leaf collection bag in place.
Attach the lower portion of the leaf collection bag to the
strap hanger on the bottom of the blower/vacuum.
Install lower tube and vacuum nozzle as described later
in this section.
To assemble the tool for blowing:
Remove the battery pack.
If applicable, lift and rotate the mode selector to the center
(unlocked) position then remove the leaf collection bag
from the rear port.
Loading ...
Loading ...
Loading ...