Loading ...
Loading ...
Loading ...
wolfappliance.com
|
21
TROUBLESHOOTING
Troubleshooting
OPERATION
Range does not operate.
• Verify power is on.
• Verify electrical power to the range and home circuit
breaker is on.
• The oven will automatically turn off after 12 hours of
continual use, except in Dehydration or Sabbath mode.
Clock display turns off.
• The clock display is in standby power mode. Refer to
page 11.
OVEN
Oven temperature issue.
• Contact Wolf Customer Care at 800-222-7820 for
recommendations.
No control knob display.
• Pull the oven control knob out and reinsert fully. Turn the
circuit breaker off for 5 seconds, then turn back on.
No response from control panel touch pads.
• Turn the oven bezel to OFF to exit Sabbath mode.
• Turn the circuit breaker off for 5 seconds, then turn back
on.
“SAb” displayed on the oven control knob.
• Turn the oven bezel to OFF to exit Sabbath mode.
“PF” displayed on the oven control knob.
• The unit had a power outage. Turn the selector bezel to a
cooking mode, then back to OFF to reset.
• Turn the circuit breaker off for 5 seconds, then turn back
on.
“OPP” displayed on the oven control knob.
• One of the ovens may be in self-clean mode. If one oven
is in self-clean, the other can not be used.
“OE”, “OC” or other error displayed.
• Contact Wolf Factory Certied Service.
Oven “pops” or “bangs” during preheat or cool down.
• Normal with new oven cavity expansion and contraction.
• Run a self-clean cycle. If it persists, contact Wolf
Customer Care at 800-222-7820.
RANGE SURFACE
Erratic ame, poor ignition or no ignition.
• Verify the burner caps are positioned properly.
• Clean the burner and igniter properly.
• If water spilled over recently, let the area dry completely.
Use a hair dryer, if desired.
• If a burner cap secures to the burner head, verify it is
tightly fastened.
• Push in the knob, then release. Verify the knob springs
back.
Charbroiler clicks continually.
• Verify the knob is set fully at HI.
Griddle indicator light ashes.
• Turn the knob off, then back on. The ame was lost and
the unit entered safety lock-out mode.
Loading ...
Loading ...
Loading ...