Kenmore 10650509990 Elite side-by-side refrigerator

User Manual - Page 6

For 10650509990.

PDF File Manual, 28 pages, Download pdf file

Loading ...
Loading ...
Loading ...
i i ii ii ii
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its f_na[location, it is
important to make sure you have the proper electrical
connection:
Recommended grounding method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused, grounded
electrical supply is required, it is recommended that a separate
circuit serving only your refrigerator be provided Use an outlet
that cannot be turned off by a switch Do not use an extension
cord
NOTE: Before performing any type of installation, cleaning, or
removing a light bu]b, turn the control (Thermostat, Refrigerator
or Freezer Control depending on the mode{) to OFF and then
d_sconnect the refrigerator from the efectr{cal source, When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat, Refrigerator or Freezer Controt
depending on the mode_) to the desired setting,
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so can result in death or
electrical shock°
,, ,,, ................................
NOTE: Before removing doors, open both doors and remove
base grille (see the "Base Grille" section)
Tools Needed:
V4in hex-head socket wrench and _A6in hex-head socket
wrench.,
1. Unplug refrigerator or disconnect power.
2. Ifyou have a dispenser (ice or water), disconnect water line
(behind base gritle).
= Remove hose from clip
a Disconnect union nut and slide it back onto tube.
=1 Remove metal insert from tube,
m Remove union nut and spring,
3.
Remove left top hinge,
= Remove hinge cover screw and hinge cover
m Remove hinge screws. DO NOT REMOVE SCREW 6 AS
SHOWN IN DIAGRAM.
N Disconnect wiring ptug and both ground wires,
5
6
7
1, Hinge Cover Screw
2, Hinge Cover
3_Hinge Piate Screws
4, Wiring Plug
5 Ground Wires
6 Do not remove this screw
Z Hinge Plate
Loading ...
Loading ...
Loading ...