Loading ...
Loading ...
Loading ...
10
the mode selector dial to the position and deliver water until the OK
light goes o. Return the selector to the I position and then proceed to make
coee.
You are recommended to deliver steam for a
maximum of 60 seconds and never to froth
milk more than three times consecutively.
MAKING MACCHIATO HOT MILK  MODEL ECP35.31
ONLY
To make hot milk without froth, proceed as described in the
above section, making sure the ring on the cappuccino maker
(A10) is positioned upwards in the “HOT MILK” position.
CLEANING THE CAPPUCCINO MAKER AFTER EVERY
USE
Important! or hygiene reasons, the cappuccino maker
should always be cleaned after use.
Proceed as follows:
1. Turn the steam dial to the position to deliver
a little steam for a few seconds (points 2, 6 and 7 of the
section “How to prepare cappuccino coee”). This causes
the cappuccino maker to discharge any milk left inside.
Turn the appliance o by turning the steam dial to the 0
position and the mode selector dial to the l position.
2. Wait a few minutes for the cappuccino maker to cool down.
Turn the cappuccino maker outwards and remove it by
pulling it downwards (g. 20).
Model ECP35.31
3. Remove the nozzle downwards (g. 21).
4. Push the ring upwards and make sure the two holes shown
by the arrows in g. 22 are not blocked.
If necessary, clean with a pin.
5. Replace the nozzle, move the ring downwards and put the
cappuccino maker back on the nozzle, turning it and push-
ing it upwards until it is attached.
Models ECP33.21 and ECP31.21
3. Remove the cappuccino maker nozzle downwards (g. 23).
4. Make sure the holes in the cappuccino maker shown in g.
24 are not blocked.
If necessary, clean with a pin.
5. Reinsert the nozzle and replace the cappuccino maker on
the nozzle, turning it and pushing it upwards until it is
attached.
HOT WATER
1. Press the ON/OFF button (g. 4) to turn the appliance on.
Wait for the OK light to come on.
2. Place a recipient under the cappuccino maker.
3. When the OK light comes on, turn the mode selector dial
to the position and at the same time turn the
steam dial to the position. Hot water comes out
of the cappuccino maker.
4. To stop the ow of hot water, turn the steam dial to the 0
position and the mode selector dial to the l position.
You should not deliver hot water for more
than 60 seconds.
CLEANING
Cleaning the machine
The following parts of the machine must be cleaned regularly:
- the drip tray (A15);
- the coee lters (C2, C3 and C4);
- the boiler outlet (A13);
- the water tank (A1);
- the cappuccino maker (A7) as described in the section “Cle-
aning the cappuccino maker after every use”.
Important!
Do not use solvents, abrasive detergents or alcohol to clean
the coee machine.
Do not use metal objects to remove encrustations or coee
deposits as they could scratch metal or plastic surfaces.
Danger! Never immerse the coee maker in water. It is
an electrical appliance.
Please note:
If the appliance is not used for more than 3/4 days, before using it again, we strong-
ly recommend you perform a rinse cycle as described in the section “Setting up the
appliance.
Cleaning the drip tray
Models ECP35.31 and 33.21: Important!
The drip tray is tted with a level indicator (red) showing the
level of water it contains.
Before the indicator protrudes from the cup tray (g. 25), the
drip tray must be emptied and cleaned, otherwise the water
may overow the edge and damage the appliance, the surface
it rests on or the surrounding area.
1. Remove the drip tray (g. 26).
2. Models ECP35.21 and 33.21: Remove the cup grille,
empty the water and clean the tray with a cloth, then reas-
semble the drip tray.
Extract the mugs or glasses tray (A14), clean with water,
dry and put back in the machine.
3. Put the drip tray back in place.
Cleaning the coee lters
Clean the coee lters regularly by rinsing under running water.
Make sure the holes are not blocked. If necessary, clean with a
pin (g. 27).
Cleaning the boiler outlet
About every 300 coees, the boiler outlet must be cleaned as
follows:
1. Make sure the appliance is not hot and that it is unplugged
from the mains;
2. Using a screwdriver, unscrew the screw xing the espresso
boiler outlet (g. 28);
3. Remove the boiler outlet;
4. Clean the boiler with a damp cloth (g. 28);
5. Clean the outlet thoroughly in hot water using a brush.
Make sure the holes are not blocked. If necessary, clean
with a pin.
6. Rinse under running water, rubbing all the time.
7. Replace the boiler outlet, making sure the gasket is cor-
rectly positioned.
Failure to clean as described above invalidates the guarantee.
Cleaning the water tank
1. Clean the water tank regularly (about once a month) and
whenever you replace the water softener lter (C7, *if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the lter (*if present) and rinse with running
water.
3. Replace the lter (*if provided), ll the tank with fresh
water and replace the tank.
4. (Models with water softener lter only) Deliver about 100
ml of water.
DESCALING
You are recommended to descale the coee maker about every
200 coees.
We recommend using commercially available De’Longhi (C6*)
descaler.
Proceed as follows:
1. Fill the tank with the descaler solution, obtained by dilut-
ing the descaler with water following the instructions on
the pack.
2. Press the ON/OFF button.
3. Make sure the lter holder is not attached and place a re-
cipient under the cappuccino maker.
4. Wait until the OK light comes on.
5. Turn the mode selector dial to the position and
deliver about 1/4 of the solution in the tank. At intervals,
Loading ...
Loading ...
Loading ...