Loading ...
Loading ...
Loading ...
GB
15
12 Light button
Press this button to turn on the display’s light and press this button again to turn off the
display’s light.
FUNCTION INTRODUCTION FOR COMBINATION BUTTONS
Combination of “ “ and “ “ buttons: About lock
Press “ “ and “ “ buttons simultaneously 3s to lock or unlock the keypad. If the remote
controller is locked, is displayed. In this case, pressing any button, blinks three times
Combination of “MODE” and “ “ buttons:
About switch between Fahrenheit and centigrade
At unit OFF, press “MODE” and “ “ buttons simultaneously to switch between ° C and ° F.
Combination of “TEMP” and “TIMER” buttons:
About Energy-saving Function
Press “TEMP” and “TIMER” simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays “SE”. Repeat the operation to quit the function.
Combination of “TEMP” and “TIMER” buttons:
About 8 ° C Heating Function (Not available)
Press “TEMP” and “TIMER” simultaneously in HEAT mode to start 8 ° C Heating Function
Nixie tube on the remote controller displays “
S
“ and a selected temperature of “8 °C”.
(46 ° F if Fahrenheit is adopted). Repeat the operation to quit the function.
REPLACEMENT OF BATTERIES IN REMOTE CONTROLLER
1. Press the back side of remote controller marked
with “OPEN” as shown the fig, and then push out the
cover of battery box along the arrow direction.
2. Replace two 7# {AAA 1.5V) dry batteries, and
make sure the position of “ + ” and “ - ” polar
are correct.
3. Reinstall the cover of battery box.
INTRODUCTION FOR BUTTONS ON REMOTE CONTROLLER
Signal sender Batteries
Reinstall
Remove
Cover off battery box
Loading ...
Loading ...
Loading ...