Loading ...
Loading ...
Loading ...
Washer Symptom Possible/Cause Solution
Load is Too Wet • Wash load may be unbalanced. The washer may have limited the
spin speed to prevent damage to the machine. Redistribute the
load and run a Spin cycle.
• Load is too small. Add items to make full load.
Wrong Water Temperature • Make sure that the controls are properly set.
• Check fill hoses. Make sure hot faucet hose is connected to hot
mixing valve (indicated with “H” on the valve bracket) and cold
faucet is connected to cold mixing valve (indicated with “C” on
the valve bracket).
• Make sure laundry room water heater is adjusted properly.
• The Normal Eco cycle uses a colder water temperature.
Control not responding to keypad selections • Make sure Control Lock feature is off. If on, Control Lock light
will be lit.
• Press and hold Signal Keypad for three seconds to turn off.
Er, do on digital display
• The control senses that the door is open during a running cycle.
• Unplug the machine to clear this code.
Er, dL on digital display
• The control senses that the door has unlocked during a running
cycle.
• Unplug the machine to clear this code.
Er, dr on digital display
• This code indicates that water is still in the washer at the end
of the cycle.
• Check the drain hose and drain receptacle to make sure they
are installed properly and not blocked.
• Foreign object trap in pump may be clogged. Clean the trap. Re-
fer to Maintenance section.
• Unplug the machine for 15 seconds to clear this code.
Er, FL on digital display
• This code will appear if the washer has not reached the fill level
after 30 minutes during a wash or rinse fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Er, nF on digital display
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed within 5
minutes of the current fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Table continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
21 Part No. 805408R3
Loading ...
Loading ...