Loading ...
Loading ...
Loading ...
- 10 -
STEP 6: Attach 4-way Wedge (Optional use, will not work with all wood)
1.
Attach 4-way wedge (#88) to the wedge (#14), pass the steel wire rope (#90) around the piston
rod and set it on the O lock ring (#89).
A
TTENTION: Cross wedge for HORIZONTAL SPLITTING use only
STEP
7:
Add Engine Oil
1.
Make sure the log splitter is on a level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Refer to the separate owner’s engine manual for the amount needed of SAE10W-30 engine oil;
replace oil fill cap/dipstick.
4. Check engine oil level daily and add as needed.
NOTE: During the break-in period check the engine oil level often.
STEP
8:
Add Gasoline to the Engine
1.
Use only clean, fresh, regular unleaded fuel with a minimum 86 octane rating.
2. DO NOT mix oil with fuel.
3. Remove the fuel cap and slowly add fuel to the tank. DO NOT overfill allow approximately ¼
inch of space for fuel expansion.
4. Screw on the fuel cap and wipe away any spilled fuel.
DANGER
Log splitter engine exhaust contains carbon monoxide, a colorless, odorless, poison gas. Breathing
carbon monoxide will cause nausea, dizziness, fainting or death. If you start to feel dizzy or weak, get
to fresh air immediately.
Operate log splitter outdoors only in a well ventilated area.
DO NOT operate the log splitter inside any building, enclosure or compartment.
DO NOT allow exhaust fumes to enter a confined area through windows, doors, vents or other
openings.
DANGER CARBON MONOXIDE, using a log splitter indoors CAN KILL YOU IN MINUTES.
CAUTION
DO NOT attempt to crank or start the engine before it has been properly filled with the recommended
type and amount of oil. Damage to the log splitter as a result of failure to follow these instructions will
void your warranty
Loading ...
Loading ...
Loading ...