Ancona AN-22128SS User Manual and Installation Instructions

Loading ...

— 10 —

Important Safety Information

GAS CONNECTIONS (All Units)

Important: Do not apply pressure directly to the appliance

manifold pipe when tightening supply connections. The

manifold pipe should be held securely at the pressure

regulator to prevent twisting. Hold the pressure regulator

with a wrench during the tightening of the connection, or

the manifold pipe may be twisted and split and cause a

dangerous leak.

Note: Check all piping connections in the unit for leaks.

Never use an open ame to check for gas leaks. Use a soap

solution, 75% water, 25% dish washing soap. It is possible

for connections made at the factory to leak, due to vibration

encountered in transportation. Make certain you have

checked them all, and repair any connections that leak.

•Theapplianceanditsindividualshut-offvalvemustbe

disconnected from the gas supply piping system during

any pressure testing of that system at test pressures in

excess of 1/2 psig.

•Theappliancemustbeisolatedfromthegassupply

piping system by closing its individual manual shut-off

valve during any pressure testing of the gas supply piping

system at test pressures equal to or less than 1/2 psig.

GAS LINE SHUT-OFF VALVE

•Toreducethepossibilityofgasleaks,applyTeontape

or a thread compound approved for use with LP or

Natural gases to all threaded connections.

•Installamanualgaslineshut-offvalveinthegasline

in an easily accessed location outside the range in the

gas piping external to the appliance for the purpose of

turning on or shutting off gas to the appliance.

•Installmale1/2’’(30-or36-inchrangetop)or3/4”(48

inchrangetop)areunionadapterto1/2”or3/4’’NPT

internal thread elbow at inlet of regulator. Use a wrench

on the regulator tting to avoid damage.

•Install male 1/2” or 3/4” are union adapter to the NPT

internal thread of the manual shut-off valve, taking care

to secure the shut-off valve to keep it from turning.

ELECTRICAL DANGER

Electrical Shock Hazard.

Do not use an extension cord.

Failure to follow these instructions can result in death,

re, or electrical shock.

•Anyadditions,changesorconversionsrequiredinorder

for this appliance to satisfactorily meet the application

needs must be made by a qualied service technician

inaccordancewiththemanufacturer’sinstructions

and all codes and requirements of the authority having

jurisdiction. Failure to follow the instructions could

result in serious injury or property damage. The qualied

agency performing this work assumes responsibility for

the conversion.

•DONOToperatethisapplianceusinga2-prongadapter

or an extension cord. If a 2-prong wall receptacle is the

only available outlet, it is the personal responsibility

of the consumer to have it replaced with a properly

grounded 3-prong wall receptacle installed by a

qualied electrician.

•Severeshock,ordamagetotherangemayoccurif

the appliance is not installed by a qualied installer or

electrician.

•Thisapplianceis120V/60Hz.Itisrecommendedto

connect to a 15-Amp or 20-Amp power supply.

•TotalInputPoweris14.1kW(AN-2160),20.8kW(AN-

2161), 27.5 kW (AN-2162), 3 A for range tops. Total

Input Power is 23.4 kW (AN-2230SS/BK/WHT), 30.2

kW (AN-2236SS/BK/WHT), 41.1 kW (AN-2248SS/BK/

WHT), 5 A for ranges. A dedicated circuit, protected by a

minimum 15 to 20-amp time delay fuse or circuit breaker

is required.

•Forpersonalsafety,theappliancemustbeproperly

grounded.

•The power supply must be the correct polarity. Reverse

polarity will result in continuous sparking of the

electrodes, even after ame ignition. If there is any doubt

as to whether the power supply has the correct polarity

or grounded, have it checked by a qualied electrician.

WARNINGS:

•ElectricalGroundingInstructions:thisindoorgas

cooking appliance is equipped with a three-prong

(grounding) plug for your protection against shock

hazard and should be plugged directly into a properly

grounded three-pronged receptacle.

•Donotcutorremovethegroundingprongfromthe

plug.

•Caution: label all wires prior to disconnection

when servicing controls. Wiring errors can cause

improper and dangerous operation. Verify proper

operation after servicing.

Loading ...

Ancona AN-22128SS 2-piece Kitchen Appliance Package

User Manual and Installation Instructions - Page 30