Loading ...
Loading ...
Loading ...
8
the percent of charge in the battery. If all four
NOTE: The state of charge LEDs will also
light when the trigger is pulled to indicate
the state of charge while the drill is in use.
SINGLE SLEEVE KEYLESS CHUCK
(FIGURE F)
WARNING: Make certain the lock-off
button is engaged to prevent switch actuation
before installing or removing accessories.
To insert a drill bit or other accessory:
1. Grasp the handle of the drill with one
hand and use your other hand to rotate
2. Insert the bit or other accessory fully
holding the handle and rotating the
chuck clockwise as viewed from the
chuck end.
WARNING: Do not attempt to tighten
the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury
may occur when changing accessories.
ON BOARD BIT HOLDER (FIGURE G)
area just above the battery pack.
LED WORK LIGHT (FIGURE G)
When the drill is activated by pulling the trigger
will automatically illuminate the work area.
NOTE: The work light is for lighting the
immediate work surface and is not intended
to be used as a flashlight.
SCREW DRIVING
should be pushed to the left. Use reverse
fasteners. When moving from forward to
trigger switch first.
DRILLING
is pushed to the left and drill mode is
selected (Figure E
be deactivated.
instructed in the Safety Instructions.
as instructed in the Safety Instructions.
instructed in the Safety Instructions.
to keep the drill bit from slipping out of it.
bit. Use enough pressure to keep the bit
biting but not so much as to stall the motor
or deflect the bit.
WARNING: When this tool is in drill
mode it may stall if overloaded,
causing a sudden twist.
Hold the drill firmly with two hands to
control its twisting action.
STALLED DRILL OFF AND ON IN AN
ATTEMPT TO START IT. DAMAGE TO
reducing pressure and slowly drilling
through the last part of the hole.
the bit out of a drilled hole. This will help
reduce jamming.
Make sure switch turns drill on and off.
DRILLING IN WOOD
Holes in wood can be made with the
same twist drill bits used for metal or with
spade bits. These bits should be sharp
and should be pulled out frequently when
drilling to clear chips from the flutes.
DRILLING IN METAL
Use a cutting lubricant when drilling metals.
The exceptions are cast iron and brass
which should be drilled dry. The cutting
lubricants that work best are sulfurized
cutting oil or lard oil.
G
9
8
F
4
Loading ...
Loading ...
Loading ...