Loading ...
Loading ...
Loading ...
7
B
C
D
1
2
heard (figure B). Ensure battery pack is
fully seated and fully latched into position.
epress
figure C and pull battery pack out of tool.
OPERATING INSTRUCTIONS
TRIGGER SWITCH & REVERSING
BUTTON (FIGURE D)
the speed of the drill.
determines the direction of the tool and
also serves as a lock off button.
switch and depress the forward/reverse
control button to the left.
reverse control button the opposite
direction.
NOTE: The center position of the control
button locks the tool in the off position.
When changing the position of the control
DRILL / DRIVE MODE SELECT (FIGURE E)
This drill is equiped with mode select
the performance of the tool to drilling or
driving based upon your project.
button marked with the
symbol.
button marked with the
symbol.
NOTE: A blue LED will light the symbol for
the mode that is selected.
AUTOSENSE
This tool is equipped with
AUTOSENSE
technology that automatically stops most
screws flush.
is pushed to the left and drive mode is
selected (Figure E
to drive a screw
into the workpiece. Drill automatically stops
most screws flush in the material on the
release the trigger and pull trigger again.
hold the trigger switch. After a moment
the drill will begin to make short rotations
to drive the screw deeper at a more
controllable pace.
release the trigger switch.
NOTE: Similar to traditional drill/drivers – it is
important to apply firm pressure to the back
of the drill to ensure the screw bit doesn’t slip
out of the screw head. If the screw bit does
slip out reinsert the screw bit and increase
your pressure to the back of the tool.
NOTE: AUTOSENSE Technology works
certain materials or screws.
STATE OF CHARGE INDICATOR
(FIGURE E)
The drill is equipped with a state of charge
indicator. This can be used to display the current
level of charge in the battery during use. It does
not indicate tool functionality and is subject
Checking state of charge during use:
shown in Figure B.
E
3
7
Loading ...
Loading ...
Loading ...