Loading ...
Loading ...
Loading ...
Fig.I
Setting Surface Controls
OPERAT(NGTHE DUAL SURFACERAD(ANT ELEMENT
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Both the 30" and 36" cooktops are equipped with dual radiant surface element
located as shown in Figs. 1 & 2. A touch key pad on the element controls is
used to select one of the 2 positions of the element. Indicator lights on the
control panel are used to indicate which coil of the dual radiant element will
heat. One indicator light on indicates that only the INNER coil will heat (Fig. 3).
Two indicator lights on indicate that both INNER and OUTER coils will heat
(Fig. 4). You may switch from either coil setting at any time during cooking.
Fig. 2
Fig. 3
Fig. 4
.
.
.
.
.
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the 0 key pad until a beep sound. The power
POWER
indicator light above the 0 will turn ON. Note: If no other key pad is
POWER
touched within 20 seconds the request to Power ON the cooktop will
clear.
3. Touch and hold the [] pad for the dual element position until a beep
ONOFF
is heard. The indicator light located above the [] pad will glow.
oN OFF
Note: If no further pads are touched within 10 seconds the request to
power the element ON will clear.
Select the INNER (Fig. 3) or INNER and OUTER (Fig. 4) to heat by touching the (_ key
size
pad.
Touch hi + pad once to turn ON the power level to HI. Touch rned pad once for
MEDIUM, touch = Io pad once for power level to LO or touch ! pad once to set the
warm
power level to KEEP WARM setting.
Each touch of the hi + or = |o pad will increase or decrease the power level. Lo is
the lowest power level available. Note: The power level may be adjusted at any time
while the element is ON.
Start most cooking operations on a higher setting and then turn to a lower setting to finish
cooking. Each surface element provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the bottom edge of the cookware
indicates the cookware is too small for the surface heating area.
When cooking has been completed touch the [] pad once to turn the element OFF
oN o_F
and if no other surface element is used touch the (D key pad to turn off the
POWER
cooktop.Note: The Hot Surface indicator Light will turn ON if the cooktop is still
hot and will remain ON until the heating surface area has cooled sufficiently.
Loading ...
Loading ...
Loading ...