Loading ...
Loading ...
Loading ...
Discrete 4 Pro Synergy Core User Manual
Page 34
Monitor incoming audio via headphones
Say you want to monitor incoming audio from mic/combo input A1 via Headphone
output 1 (HP1), both on the front panel. Connect your equipment and open the
Control Panel. Do the following:
1. In the 'PREAMPS' section, head to the leftmost preamp and click the middle symbol to
the right of the volume indicator until you get:
● A microphone symbol if you plugged in a mic. If it's a condenser, activate 48V
phantom power from the button below the gain knob.
● A guitar symbol if you plugged in a guitar or bass.
● A jack symbol if you have plugged in a line level source (synths, samplers, players
and so on).
2. Go to the ‘MIXER’ tab and make sure that ‘PREAMP 1’ is selected as a channel source
on any of the four available mixers. For this example, we’ll use ‘MIXER 1’ and select the
source on the first mixer channel.
To hear the input on one of the headphone outputs, open either the ‘HEADPHONE 1’ or
‘HEADPHONE 2’ tab on the bottom of the software panel and choose the two ‘MIXER 1’
channels as sources for your headphone outputs.
The source selection is located on the left side of large volume rotary knob, and it’s
marked with ‘L’ – ‘R’ corresponding to the left and right mono outputs.
Click on ‘L’ and select ‘MIXER 1 OUT - 1’ for the left channel. Click on the ‘R’ select
‘MIXER 1 OUT - 2’ for the right channel. This will feed your headphones with the stereo
output of the first mixer.
You should be hearing audio from the input in your headphones. Adjust input gain from
the gain knob in the 'PREAMPS' section and output volume from the mixer channel fader
or the 'HEADPHONE 1' knob.
You can also use the front panel controls.
Apply Synergy Core FX to incoming audio
Go to the ‘AFX’ tab to access the Synergy Core processing functionality. Choose your
audio input(s) from the input selectors for the available 16 channels. Click the area below
the input selector to open the corresponding Synergy Core FX rack window. Click the
'ADD NEW EFFECT' button to start building your effects chain and adjusting effects
settings. Close the window when you are done. An in-depth overview of the FX Rack can
be found later in the manual.
Loading ...
Loading ...
Loading ...