Loading ...
Loading ...
Loading ...
4 5
7.
Pendulum with Lasers
8.
Horizontal Line Apeture
9.
Vertical Line Apeture
10.
Plum Spot Apeture (
93LCLS
)
1.
Horizontal Line On/Off Button
11.
Battery Compartment Door
2.
Vertical Line On/Off Button
12.
1/4-20 Tripod Mount
3.
Plum Spot On/Off Button (
93LCLS
)
13.
5/8-11 Survey Tripod Mount
4.
Low Battery Indicator
14.
Magnetic Mount Bracket
5.
Excessive Tilt Indicator
15.
Magnets
6.
Power/Pendulum Lock/Unlock Switch
16.
Clamp-On Wall Adapter
FEATURE DETAILS
NOTE: There are no user-serviceable parts inside this instrument.
SYMBOLS ON INSTRUMENT
Vertical
Laser Line
Low Battery
Indicator
Ingress Protection IP54 Rating –
Dust & Water Resistant
Horizontal
Laser Line
Excessive
Tilt Indicator
Hazardous laser radiation, DO NOT
stare into beam or view directly
with optical instruments
Plumb Spot
Laser
Battery
Polarity
Warning or Caution
OPERATING INSTRUCTIONS
TURNING LASER BEAMS ON/OFF
Push the ON/OFF buttons for the horizontal line
1
, vertical line
2
, and plumb
spot
3
(93LCLS model only) to turn ON and OFF their respective laser lines. These
buttons are only active once the Pendulum Lock/Unlock Slider Switch
6
has
been set to the Unlocked position. If the Pendulum Slider Switch is moved from the
Unlocked to the Locked position while the laser beams are active, they will be turned
OFF. The different laser lines can be operated independently or simultaneously.
NOTE: The plumb spot application projects laser beams both in upward and downward
directions. The downward beam may be used to locate a specific point on a floor
layout while the upward beam projects that same point to a ceiling.
PENDULUM SLIDER SWITCH & SELF-LEVELING
The laser assemblies are mounted on a pendulum so that the instrument can self-level.
The Pendulum Slider Switch
6
must be in the unlocked position for the instrument
to self-level. If the instrument is tilted by >4° from the horizontal plane, the pendulum
will not be capable of self-leveling; the active laser beams will flash and the Excessive
Tilt Indicator
5
will blink to indicate that the instrument is not level and cannot
self-level. The instrument must be repositioned on a more level geometry for the self-
Leveling pendulum to function appropriately.
Horizontal Laser Line Vertical Laser Line Plumb Laser Line
NOTE: If the instrument indicates that it is not
level (via flashing beams and/or a blinking
Excessive Tilt indicator
5
),
then it should not
be used for laying out level or plumb lines.
NOTE: Following use, the active laser beams
must be turned OFF and the Pendulum Slider
Switch must be placed in the Locked position
prior to storage.
16
2
6
7
8
5
10
3
1
9
4
TOP
11
SIDE
BACK
1213
BOTTOM
14
Instrument Tilted Excessively
15
ENGLISH
Loading ...
Loading ...
Loading ...