Craftsman 917252560 lawn tractor

User Manual - Page 16

For 917252560.

PDF File Manual, 56 pages, Download pdf file

Loading ...
Loading ...
Loading ...
CUSTOMER RESPONSIBILITIES
TRACTOR
Always observe safety rules when performing any mainte-
nance,
BRAKE OPERATION
If tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted
(See "TO ADJUST BRAKE" in the Service and Adjust-
ments section of this manual).
TIRES
o Maintain proper air pressure in all tires (See "PROD*
UCT SPECIFICATIONS" on page 3 of this manual).
. Keep tires free of gasoline, oit, or insect control chemi-
cals which can harm rubber.
= Avoid stumps, stones, deep ruts, sharp objects and
other hazards that may cause tire damage.
BLADE CARE
For best results mower blades must be kept sharp.. Re-
place bent or damaged blades.
BLADE REMOVAL (See Fig. 12)
Raise mower to highest position to allow access to
blades.
° Remove hex bolt, Iock washer and fiat washer securing
blade.
o Install new or resharpened blade with trailing edge up
towards deck as shown,
, Reassemble hex bolt, lock washer and flat washer in
exact order as shown.
- Tighten bolt securely (30-35 Ft, Lbs. torque).
IMPORTANT: BLADE BOLT 1SGRADE 8 HEATTREATED
NOTE: We do not recommend sharpening blade * but if you
do, be sure the blade is balanced_
----_ MANDREL
__ ASSEMBLY
*A GRADE 8 HEAT TREATED BOLT CAN BE IDENTIFIED
BY SIX LINES ON THE BOLT HEAD.
FIG. 12
TO SHARPEN BLADE (See Fig. 13)
Care should be taken to keep the blade balanced. An
unbalanced blade will cause excessive vibralon and even-
tuat damage to mower and engine.
. The blade can be sharpened with a file or on a grinding
wheel. Do not attempt to sharpen while on the mower.
. To check blade balance, you wii need a 5/8" diameter
steei bolt, pin, or a cone balancer (When using a cone
balancer, fotow the instructions supplied with baF
ancer),
° Slide blade on to an unthreaded portion of the steel bolt
or pin and hold the bolt or pin parallel with the ground,
If blade is balanced, it should remain in a horizontal
position, tf either end of the blade moves downward,
sharpen the heavy end until the blade is balanced.
NOTE: Do not use a nail for balancing blade., The lobes of
the center hole may appear to be centered, but are not.
j'
/
I
/ >
eta'BOLT.J "_k.l/',_
OR PIN _
FIG. 13
BATTERY (See Fig. 14)
Your tractor has a battery charging system which is suffi-
cient for normal use. However, periodic charging of the
battery with an automotive charger will extend its life.
= Acid solution level in each battery cell should be even
with bottoms of vent wells. Add only distilled or iron free
water if necessary. Do not overfill,
, Keep battery and terminals clean,
, Keep battery bolts tight°
Keep vent caps tight and small vent holes in caps open.
o Recharge at 6 amperes for I hour.
CUT AWAY VIEW
VENT CAP
VENT
WELL
BATTERY
CELL ACID
LEVEL
FIG. 14
16
Loading ...
Loading ...
Loading ...