Loading ...
Loading ...
Loading ...
~ 3 ~
Important! For electrical connection carefully follow the instructions given in specific paragraphs.
Unpack the appliance and check for any damages. Do not connect the appliance if it is damaged. Report
all damages immediately to the retailer and retain the packing.
Please allow the unit to stand for at least four hours before connecting to allow the oil to flow back in
the compressor.
Allow adequate air circulation around the appliance to avoid overheating. To achieve sufficient
ventilation, follow the instructions in the relevant section.
Wherever possible the spacers of the unit should be against a wall to avoid touching or catching warm
parts (compressor, condenser) to prevent possible burn.
The appliance should not be situated close to radiators or cookers.
Ensure the mains plug is easily accessible after the installation of the appliance.
Service
This appliance must be serviced by an authorised Service Centre, and only genuine spare parts must be
used.
Any electrical work required after servicing of the appliance, should be carried out by a qualified
electrician.
Energy Saving
Do not put hot food in the appliance.
Do not pack food close together as this prevents air circulation.
Ensure food does not touch the back of the compartment(s).
In the event of a power cut or malfunction, do not open the door.
Do not open the door frequently.
Do not keep the door open for too long time.
Do not set the thermostat on exceeding cold temperatures.
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant
circuit or insulation materials. The appliance shall not be discarded with domestic waste. The insulation
foam contains flammable gases. Observe local environmental standards when disposing off the appliance,
which can be obtained from your local authorities. Avoid damaging the cooling unit, especially the heat
exchanger. The materials used on this appliance marked by the symbol is recyclable.
Loading ...
Loading ...
Loading ...