Loading ...
Loading ...
Loading ...
installation & maintenance_17
CONNECTING THE WATER SUPPLY HOSE
• Connect the other end of the water supply hose to the
inlet water valve at the back of the washer. Screw the hose
clockwise all the way in.
• Connect the other end of the water supply hose to the
inlet water valve at the back side of the washer. Screw
the hose clockwise all the way in.
• If the water tap is a screw type, assemble a water supply
hose that fits to the tap as shown. After completing
connection, if water leaks from the hose, then repeat the
same steps.
After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big, remove the spacing ring before inserting the faucet
into the adaptor.
HOW TO CONNECT THE DRAIN HOSE
IN CASE OF PUMP-DRAINED WASHER
Be sure to join tlghtly the drain hose into the drain-
outlet on the side of the machine.
Verify that the retaining ring stay in his correct
position.
90 ~ 100 cm
Drain hose
Hose guide
The drain hose has to be arranged vertically at 90°
to the base.
Install the drain hose in the position of about
90~100 cm above the ground. The end of the drain
hose can not be sinked under water.
03 INSTALLATION & MAINTENANCE
F700S_DC68-03271Q-00_EN.indd Sec6:17F700S_DC68-03271Q-00_EN.indd Sec6:17 6/13/2019 6:44:48 PM6/13/2019 6:44:48 PM
Loading ...
Loading ...
Loading ...