Loading ...
GENERAL SAFETY RULES
WARNING! Before using this electric tool. Carefully read the general safety
rules listed below.
1 Your sockets must comply with safety rules. In case your sockets are not
suitable, they should be checked by a skilled electrician.
2 Your socket plug must absolutely be grounded and your electric system
must be supplied with a magneto cut-out safety.
-When the machine is running unwatched, be careful that children cannot
reach it.
-Do not pull the electric cable to disconnect the plug.
-The machine shall be protected from frost and low temperatures.
3 In case the machine cannot hoist a load, do not keep pressing the hoisting
push button: this means that the load exceeds the machine's maximum
capacity.
-The machine shall not be disassembled when running or connected to power.
-Do not stand under hoisted weights.
4 Before starting the work, make sure that the steel cable is correctly winded
around the reel and the pitch is equal to the cable diameter.
5 Observe the maximum load indicated on the hoist, not that no the hook!
6 Leave at least three turns of cable around the reel so that the cable
connection is not under stress.
-To avoid any danger, do not wind more than 15m of cable around the reel.
7 In case the steel cable is worn out, it must be replaced only with a cable of
the same features manufactured by us. It can be found at all authorized service
shops.
-Before starting the word, check that switches are in good operating conditions.
8 In case the hoist stops during the lowering of a load, it is normal that the
load goes down a few centimeters more because of inertia.
9 Attention! The hoist electric motor is not supplied with any overload cut-
out(to avoid an unexpected and unwanted restart) therefore, if you are unable
to hoist a load do not insist and let the motor cool down.
MAINTENACE
-Periodically CHECK that the steel cable is in good condition.
1 CHECK that the screws securing the brackets and reduction gear are
well tightened.
2 CHECK THE CONDITIONS AND TIGHTENING OF THE NUTS
securing the steel cable clamps.
3 Periodically CHECK that the motor stop switch and push button
switch are in good operating conditions.