Loading ...
Loading ...
Loading ...
EN - 17
UNCLOG BAGGER
If hose or blower assembly clogs, stop
forward motion and allow unit to clear itself. If
unit will not clear itself, unclog the hose
and/or blower assembly manually as
instructed below.
1. Stop engine and remove ignition key.
Wait for all moving parts to stop.
2. Remove hose from bagger.
3. Remove hose from blower assembly.
NOTICE: Perform steps 4 and 5 if clog is in
the hose:
4. Remove clogged grass.
5. Reinstall hose.
NOTICE: Perform steps 6 and 7 if clog is in
blower assembly.
6. Clear grass from blower assembly.
7. Reinstall hose.
OPERATING TIPS
• Cut grass when it is dry.
• Cut grass in two passes when cutting thick,
long, or wet grass. Make the first cut higher
than desired. Make the second cut at
desired height.
• Always use full throttle when bagging.
1. Disconnect hose from bagger.
2. Support bagger and pull bagger rope.
Lower bagger to ground and lift off bagger
mounts. See Figure 26.
WARNING: MOVING PARTS
can cut or amputate body parts.
NEVER attempt to clear blower
assembly while engine is
running.
ALWAYS stop engine, remove
key, and wait for moving parts to
stop.
Sharp edges can cut. Movement
of parts can cut off fingers or a
hand. Wrap blade(s), wear
sturdy gloves and use extreme
caution when working near
blades or impeller.
WARNING: PINCH POINT! Use
extreme caution when
unclogging blower assembly.
Impeller can cut or pinch your
hand, even when not in
operation. DO NOT place hands
in blower assembly.
WARNING: Blades rotate when
impeller rotates. Impeller rotates
when blades rotate. Block
blades to prevent rotation before
proceeding.
REMOVAL
CAUTION: Bagger assembly
will rotate backward when latch
is released. Support bagger
assembly before pulling rope to
unlock latches.
Figure 26
Loading ...
Loading ...
Loading ...